Instructions / Assembly

Pg 12 of 15
17.
P
I
E
16.
D
distance minus 2
cut here
discard this end
factory metal insert
Subtract 2 in. from the measurement
from step 15. Measuring from the end of
the tube with the factory metal insert,
mark this measurement on long straight
tube (D). Using a hacksaw, cut long
straight tube (D) at the mark.
IMPORTANT
:
Be sure to subtract 2 in. from the measurement from step 15.
Before you cut, make sure you measured from
the end of the tube with the factory metal insert.
R
Put part E on the outside of the tube E, then set screw (P) goes thru part I and
installed in tube E.