User's Manual

68 Chapter 5 Web-based Configuration
Figure 35 Table 5-2 NAT Configuration Specification
Field Description Default Value
Enable NAT Enable or Disable NAT Disable
NAT Mode Two NAT modes are
available after enable NAT,
NAPT mode and Basic
NAT mode
NAPT
NAT Timeout NAT timeout options: 1-
3600 seconds
120
NAT Interface
inside
NAT Interface inside LAN Port
NAT Interface
outside
NAT Interface outside WAN port
Configuration Description:
When NAT is enabled, select NAPT mode. Click <Apply> to
apply the configuration and click <Advanced> to take effect. For
more details, refer to the section 5.11.1 to configure the IP
address based mapping and port based mapping.
When NAT is enabled, select Basic mode. Click <Apply> to
apply the configuration and click <Advanced> to take effect.
User should configure the link between “NAT Pool” and “NAT
Static Map” based on port.
NAPT Mode
Access Method: