User's Manual

Chapter 4 Web-based Configuration 21
WA3001-S Access Point User Guide
Basic Configuration
This section introduces each item of the basic configuration of WA6011
including WAN, LAN and wireless port configuration.
Click “Basic Config” on left panel of the Logon interface, the basic
configuration items of the AP will be displayed. The following sections will
describe each item.
AP Mode Configuration
Click “AP mode” on left panel of the Logon interface, see Figure 20, Route
Mode is the default. Click <Apply> after configuration completed. See Figure
21, the popup dialogue box prompts that the configuration will not work until
it’s saved, then reboot the AP.
Figure 20 AP Mode Configuration
Figure 21 Prompt Window after Apply AP Mode Changes
Wireless Port1/Wireless Port 2 Configuration
Two wireless network cards can be installed in WA6011. Their
corresponding configuration ports are wireless port 1 and wireless port 2.
Figure 22 displays the port configuration without wireless network card
plugged.