User's Manual

Chapter 4 Web-based Configuration 31
WA3001-S Access Point User Guide
Parameters Specifications Default
DTIM Interval
Interval between Delivery
Traffic Indication Messages.
2 x Actual
beacon
interval
Power
Transmitting power of the AP
wireless port. Possible
values: 12％，25％，50％，
100％.
100%
(400mw)
Tx Rate
Transmission rate. The
range of selectable values is
decided based on the
wireless mode set in the
basic configuration. If Auto is
chosen, the network card will
select current the optimum
rate.
auto
Basic Rate
The network card is
restricted to operating at a
selected Tx rate at least.
1,2,5.5,11Mb
it/s
Antenna
Possible values: Both, Ant A,
Ant B
Both
RTS/CTS
Threshold
WLAN is using the
mechanism of Request To
Send/Clear To Send.
RTS/CTS threshold can be
set, RTS/CTS is used when
the data packet size exceeds
the threshold. Choose a
setting within a range of 0 –
2347. It is advisable not to
change this setting.
2346
Fragment
Threshold
Fragment threshold is used
to improve the efficiency in a
high volume wireless
network. Define the data
packet size limit here. Any
packet greater than this
value will be fragmented.
Choose a setting within a
range of 256 – 2346 bytes. It
is advisable not to change
this setting.
2346
WA6011 is able to work in multiple modes:
• AP mode: The AP is connected to the WAN through its uplink port and
provides access to the wireless network through its wireless ports. In
this way, the AP implements a combination of a wireless network with
the WAN.
• Repeater mode: The AP is implemented as a signal relay that enhances
signal strength. In this way, it extends the coverage of the wireless
network. The central AP is connected to the WAN and the remote APs
are connected to the central AP in bridge mode.