User's Manual

Chapter 4 Web-based Configuration 33
WA3001-S Access Point User Guide
• Server dead time/Server timeout time/Server transmit times: If the
request sent to the Radius Server does not get a response within
Timeout value, the request is re-sent to the server until the number of
re-tries reaches the value set in the Transmit Times. If any re-try does
not get a response, then the AP considers that the Radius server failed.
It will wait a period of time as defined in the Dead Time. Then the AP will
re-send a request.
Authentication
WA6011 provides 802.1x authentication mode. The user can configure the
static or dynamic user information through “Subscriber”, and configure
802.1x authentication through “802.1x Authentication Config”.
Click “Advanced Config/Authentication”, see the configuration details in
Figure 42.
Figure 42 Authentication Configuration
• User Authentication Configuration user interface is shown in Figure 43
Figure 43 User Authentication Configuration
- Port: Display the installed wireless ports of Wireless port 1 and
Wireless port 2
- 802.1x Authentication: disable or enable, the default is “disable”
- Authentication Mode:
The available options are:
 None
 local-remote: WA6011 is the authentication point.
 remote: RADIUS server authentication.