User's Manual

38 Chapter 4 Web-based Configuration
User Guide WA3001-S Access Point
Figure 52 Route Configuration
Enter IP address, Mask and the IP address of the Next Hop, click <Add> to
add a new route entry. The <Refresh> button is used to refresh the display
of all route entries. The <Remove> button is used to remove a route.
NAT Configuration
Click “Advanced/NAT”, NAT (Network Address Translation) configuration
interface is shown in Figure 53
Figure 53 NAT Configuration
Select “Enable NAT”, choose either NAPT mode or Basic NAT mode. The
range of NAT Timeout is 1 – 3600 seconds. Click <Apply> to take the
configuration effect, and then the NAT Advanced Configuration is available.
• NAPT (Network Address and Port Translation) mode configuration is
shown in Figure 54