User's Manual

54 Chapter 5 Typical Configuration Examples
User Guide WA3001-S Access Point
AP in Router Mode
Take WA6011 as example:
Description:
This example setup is used for establishing a small range network consisting
of less than 10 users. AP supports IEEE 802.1x. There has a remote
Radius/AAA (Authentication, Authorization and Accounting) server.
AP Configuration Information:
- AP working mode: Route mode
- IP address for AP’s WAN interface: assigned through DHCP server
- IP address for AP’s LAN interface: the default one is 172.18.37.1
- AP acts as a DHCP server to assign the IP addresses for the
WLAN
- Managed by NAT
- Configure the Radius server
- Enable the 802.1x authentication of AP, set the maximum number
of online users to 10
Detailed Instruction:
Step 1: Set the working mode to “Route mode” through the “Guide” link, get
the WAN interface IP address through DHCP server, user the default IP
address for LAN interface, and configure SSID. Click <Apply>, the pop-up
window will remind user to save and reboot the AP to effect the configuration.
Step 2: Enable the DHCP Server through the “Basic Config/DHCP Server
Configuration” link, set Network IP, Network Mask, DNS server and other
parameters. Set the Gateway IP address to the one for AP LAN port, and
then click <Apply>.