User's Manual

56 Chapter 5 Typical Configuration Examples
User Guide WA3001-S Access Point
Step 6: For the detail of SSID configuration in client wireless network card,
please refer to the section “AP in Bridge Mode” in Chapter 5.
AP in P2P Mode
Take WA6012 as example:
Configuration Information:
Set the working mode of AP-1 and AP-2 to Bridge mode, connect AP-1 to
the network through its uplink, AP-2 connects to the network through AP-1.
For example, wireless bridging can be done through network card 1 of AP-1
and AP-2
AP-1 Configuration:
- Set the working mode to Bridge mode
- Through the “Advanced Config/Wireless Port 1” link, select
“Repeater mode”, click <apply>, the pop-up window will remind
user to save and reboot the AP to effect the configuration.
- Click <OK>, the WDS configuration user interface appears. Add
AP-2’s MAC address into the “MAC address” field. Click <Add>, the
address will be displayed in the MAC address table.