Page III. How do I... How do I... These operations need to be performed in standby mode. When the left soft key function is Menu, the phone is in standby mode. To return to standby mode, press . Press and hold Make a call Key in the phone number and press Answer a call Press End or reject a call Press (Hangup) or flip cover. Clear a keypad entry Press Use speed dial Press and hold the speed dial key to display the phone number, and then press .
Page 1 1. Overview The UTStarcom F3000 Handheld is a wireless Voice over IP (VoIP) telephone that, when coupled with VoIP phone service, combines the benefits of Internet telephone service, with mobility. This guide covers how to configure and use your F3000 to make VoIP phone calls via the service network. You can make and receive calls as long as you are within range of a wireless access point. See the F3000 User Manual for more information on all features. 2.
Page 3 3. Connecting to a Wireless Network Your F3000 WiFi phone has been preconfigured to provide VoIP phone service via any available open wireless Access Point (AP) connected to the Internet. If you want to use a specific AP or your AP is protected by encrypted access, refer to Section 3.2. 3.1 Connecting to Open Access Points When you turn on the F3000, it searches for available APs, selects the AP with the best signal and attempts to connect to it.
Page 5 3. Connecting to a Wireless Network Once connected (and provisioned when necessary), you will see the message "Registering via APname". When the right soft key function displaying Names in standby mode, you are ready to make and receive calls. Note: If the WiFi phone cannot connect to an AP, it will keep searching and wear down your battery. Verify open AP availability. If not found, turn off the phone until you are within range of an Access Point. 3. Connecting to a Wireless Network Page 6 1.
Page 7 3. Connecting to a Wireless Network 3.3.2 Entering SSIDs Directly If the desired AP has broadcast turned off, you can save the AP by entering SSID information directly. to scroll to WiFi and to select WiFi Config; press 1. Press (Menu); press press (Ok); press to select AP Profile. 2. Press to reach the desired AP profile and press (Ok). Press to select the SSID option. 3. Enter the desired AP's SSID and press (Ok). 4. Follow steps 3-4 specified in Section 3.3.1. 3.
Page 9 5. Troubleshooting These are the most common problems and solutions that come up when starting to use the F3000 WiFi phone. If you are having trouble placing a phone call, go through this checklist until your problem is solved: 5. Troubleshooting Page 10 The phone cannot be switched on: - Press and make sure you hold it down for more than 2 seconds. I cannot make a phone call: - If it still doesn't switch on, check your battery. If necessary, charge the battery.
