User guide

Chapter 5 Advanced Configuration / Network Management 51
From the Protocol drop-down menu, select the protocol that
you want this rule to apply to. You can select from the
TCP
,
UDP
,
ICMP
, or
Any
protocols. If
Any
is selected, this rule will
apply to any packets that has one of the specified IP addresses
as its source or destination.
You can also specify a range of TCP or UDP ports for this rule
to apply to in the
Port Range
fields.
The
Schedule
field allows you to specify when the UT-300R2
router will enable this rule. Click always if you want this rule to
be enabled at all times. Otherwise, click the
from
radio button
and enter the time and day of the week you want this rule to be
enabled.
Click the Apply button to enter the rule into the IP Filters List
and restart the router.
Directory Configuration and Read-only Menus
IP Filters
This radio button selects the IP address filter rule
entry page, which will be displayed when you click
on it.
MAC
Filters
This radio button selects the MAC address filter
rule entry page, which will be displayed when you
click on it.
URL
Blocking
This radio button selects the URL filter rule entry
page, which will be displayed when you click on it.
Domain
Blocking
This radio button selects the Domain name filter
rule entry page, which will be displayed when you
click on it.
Status
This set of radio buttons allows you to enable or
disable this rule.
Name
You can enter a name for the rule, for easier
identification later.