Installation Sheet

STYLE#:
21328
Carefully unpack all lamp parts from the carton.
1. Take the lamp carefully out of the Carton,and place it on a flat surface.
2. Be sure the power to the installation point is power off. This land must be installed on reinforced Outlet Box.
3. Fasten the Cross bar to the outlet box .Secure the Nipple onto the Canopy with Loop #1.
4.Adjust chain length as needed. Thread Quick Link#1 into Loop #1 on the Canopy, then Quick Link #2 into Loop #2 on the Lamp Body.
Hand tighten until snug.
5. Pass the supply wires through the Canopy and the hole in the middle of the Cross Bar.
6. The power supply wire consists of three wires, one black wire, one white wire and one silver ground wire.
Connect the wires as shown.A. Connect the House Ground Wire to the Fixture Ground Wire.
B.Connect the House White (or Ribbed) Wire to the Fixture Supply Wire (White or Ribbed Side).
C.Connect the House Black (or Red) Wire to the Fixture Supply Wire (Black or Smooth Side).
D.Wrap each connected wire with Wire Connector and carefully stuff all of the connected wires into the Outlet Box.
7.Put the Glass Shade onto the Shade Base separately with care.
8. Install the correct Edison Bulb (Included）onto the Socket referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity.
ASSEMBLY INSTRUCTIONS