Installation Guide

CAUTION-RISK OF FIRE. CONSULT A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH
CIRCUIT CONDUCTOR MIN 90 ℃ SUPPL
Y
CONDUCTORS.
LISTED
INSTALLATION INSTRUCTION
For Flush Mount Ceiling Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. .
MOUNTING THE FIXTURE
1. Shut off power at the fuse box or circuit breaker box.
Remove the old fixture from ceiling. Including the
crossbar.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Thread the two Mounting Screws (A) about 1/4” into
the pre-drilled holes in the Crossbar (B) spaced the
same
distance apart as the holes in the Ceiling Pan (D).
4. Attach the Crossbar (B) to the Outlet Box using the
two Screws (C) from the Outlet Box. The side of the
Crossbar marked “GND” must face out.
5. While holding the Ceiling Pan (D) toward the ceiling,
Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house
(hot)
wire. Connect the white wire from the fixture wire to
the white (neutral) house wire. Make sure all wire nuts
are secured. You may wrap the connections with
electrical tape. If your outlet has a ground wire (green
or bare copper) connect fixtures ground wire to it.
Otherwise connect fixture’s ground wire directly to the
crossbar using the
green screw provided. Tuck the
wire connections neatly into the ceiling junctions box
as you hold the Ceiling Pan assembly toward the
ceiling.
6. Finish mounting the Ceiling Pan (D) by placing it over
the Crossbar (B) with Mounting Screws (A) so that
they protrude through the “Keyholes” in the bottom of
the pan. Rotate the Pan until the screws are in the
slots of the “Keyholes” and tighten with a screwdriver.
7. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
8. Thread the Nipple (E) into the Ceiling Pan (D). Place
the Glass Shade (F) over the Ceiling Pan (D) allowing
the Nipple (E) to protrude through the bottom hole in
the glass.
9. While holding the Glass Shade, and place a washer
and mounting Nut through the Nipple (E), slide Bottom
Cap (G) tighten finial (H) against Ceiling Pan (D).
Your installation is now complete. Return power to the
junction box and test the fixture.
CST018
OUTLET BOX
(CEILING)
Fig.1
A
B
C
D
E
F
G
H
Fig.2
FIXTURE
WIRES
Black o
r
S
m
oot
h
FIXTURE
WIRES
White o
r
Ri
bbed
FIXTURE
WIRES
Green or
Bare
Copper
(
Ground
)
HOUSE
WIRES
Black
(
H
ot)
HOUSE
WIRES
White
(
N
eut
r
a
l
)
HOUSE
WIRES
Green or
Bare Copper (Ground)