Owner's manual

PCR Workstations and Cabinets Page 5
Assembling the PCR System
Carefully remove the PCR Hood components from the packaging. CAUTION: Use care when
unboxing the PCR Hood, as staples with sharp ends may have been used in packaging.
Follow the assembly instructions provided in this manual. NOTE: Place the PCR Hood Base on a
level surface large enough to accommodate the entire Base. The surface must be level to ensure
proper alignment of the Makrolon
®
panels.
Required Tools
• Philips head screwdriver (motorized, if available)
• Flathead screwdriver (motorized, if available)
• Gloves, to reduce transfer of fingerprints to PCR Hood components
• Two people for assembly and lifting of the equipment
NOTE: Assembly drawings show the 95-0436-01 UV2 PCR Cabinet. However, these instructions
apply for all PCR models.
Outer Back Panel
1. Separate the Inner and Outer Back Panels by removing the 4 screws, as shown:
NOTE: The Outer and Inner Back Panels and Shelf Bracket are assembled at the factory for
shipping purposes.
2. Loosen the two screws on the Base Assembly, as shown: