GelCam 310 Camera Installation and User Instructions UVP, LLC 2066 W. 11th Street Upland, CA 91786 Phone: (800) 452-6788 / (909) 946-3197 Fax: (909) 946-3597 Ultra-Violet Products Ltd. Unit 1, Trinity Hall Farm Estate, Nuffield Road, Cambridge CB4 1TG UK Phone: +44(0)1223-420022 Fax: +44(0)1223-420561 Web Site: www.uvp.
GelCam 310 2 Introduction The high sensitivity, non-cooled CCD GelCam 310 Camera is designed for use with a variety of UVP’s Imaging Systems. The instruction manual covers assembly of the camera on the darkroom and installation of software. Refer to the system (manual for additional system information and the VisionWorksLS Software Manual or Help Files for software information. Components Specifications Type Resolution Megapixels Bit Depth PC Interface GelCam 310 Camera Monochrome 1600 x 1200 2.
GelCam 310 1. Align the holes of the gasket and base. Attach the base and gasket to the darkroom using the screws provided. Position the bracket on the mounting base aligning the holes on the base. Using the four thumb screws provided, secure the bracket to the base. 2. Place the camera and lens assembly into the camera bracket. Push the lens through the center hole in the gasket. The gasket forms a seal around the lens. Insert and tighten the knob/washer to secure the camera to the bracket.
GelCam 310 4 GelDoc-It with Motorized Lens This configuration comes with: GelCam 310 Camera Motorized lens Lens control box +2 diopter Bracket Base (typically shipped on system) USB Cable (for connection from camera to PC or TS) USB Cable (for connection from motorized lens control box to PC or TS) Bracket mounts on top of filter tray for the TS unit Note: The above images are for clarification only, and may be different than the system shipped. Hardware Installation 1.
GelCam 310 5 6. Plug in the serial cable from the motorized lens to the lens control box. 7. Plug the 90 degree cable into the top of the camera. Leave the other end unplugged until you are ready to install the Visionworks disk. 8. Connect the cable to the PC connection port on the lens control box. Leave the other end unplugged until ready to install the USB Drivers disk. 9. Connect the power supply to the lens control box and into the power outlet.
GelCam 310 6 BioSpectrum with Motorized Lens This configuration comes with: GelCam 310 Camera Motorized lens Lens control box +2 diopter Bracket Base (typically shipped on system) USB Cable (for connection from camera to PC) Hardware Installation Slide the camera and lens assembly into the camera base. USB Connection for camera Plug in the serial cable from the motorized lens to the darkroom. 1. Plug the 90 degree cable into the top of the camera.
GelCam 310 7 Knob for attaching camera to bracket Bracket and base securing camera Software Installation (for BioSpectrum) The lens is controlled through VisionWorks®LS software. Note: Make sure the system has at least a VisionWorksLS Version 7 before continuing with the installation. Install the Lens Control Driver 1. Unplug the Motorized Lens at the top of the BioSpectrum then plug it back in. 2. A Found New Hardware wizard will appear.
GelCam 310 8 Technical Support UVP offers free lifetime technical support on all of its products and software. Should you have any questions regarding the product’s use, operation or repair, contact UVP’s offices at the locations below, or visit www.uvp.com.
