Owner manual

ManualsBrandsUVP ManualsLightingR-52G

Mineralight and Blak-Ray are registered trademarks of UVP, LLC.

Lamp Grid

The lamp has a special grid available only from UVP LLC. If broken, return the

grid and reflector to the factory together to assure a proper fit when the new grid

and reflector are returned.

Remove the filter frame as described above. Then, remove the five screws from

the lower housing. Unscrew the two wire nuts. Remove the four screws holding

the reflector to the lamp housing. Pack the tube and reflector carefully to decrease

the chance of breakage.

Helpful Hints

These ultraviolet lamps are designed for use in dark or semi-dark areas. Allow

enough time for your eyes to adjust to the darkness prior to using the lamp.

Some materials will tend to fluoresce more brightly than others. This reaction is

due to the concentration of fluorescence on the material and the varying degrees

of brightness of different colors.

Replacement Parts

Part Description Part Number

Lamp Grid 77-0002-02

Filter Frame 98-0004-03

Accessories

Blak-Ray

Safety Goggles and Contrast Control Spectacles

Special formula lenses completely eliminate "blue haze" interference while

protecting eyes from harmful bands of UV. UVC-503 Goggles (part number 98-

0002-02) provide maximum safety from extended or high intensity UV light

sources. UVC-303 Spectacles (98-0002-01) are used for sporadic lower intensity

UV light sources and can be worn comfortably over prescription glasses. The

UVC-803 Faceshield (part number 98-0002-04) provides similar UV protection for

the entire face.

Ultraviolet Intensity Meters

For the widest energy range measurements, high accuracy and interchangeable

sensors for measurements at 365nm, 302nm and 254nm, the UVX Digital

Radiometer can be used. Units are handheld, battery operated and have compact

sensors with 3-foot electrically shielded cords. Also available are Blak-Ray Meters

in models J-221 for the measurement of longwave (365nm) UV, or J-225 for the

measurement of shortwave (254nm) UV. The meters are compact and highly

accurate.

R-52G Mineralight

UV Lamp

Instruction Guide

___________________________________________________________

UVP, LLC

2066 W. 11th Street, Upland, CA 91786

Tel: (909) 946-3197 / (800) 452-6788

Fax: (909) 946-3597

Web Site:

www.uvp.com

81-0018-02 Rev D

Ultra-Violet Products Ltd.

Unit 1, Trinity Hall Farm Estate

Nuffield Road, Cambridge CB4 1TG UK

Tel: +44(0)1223-420022 Fax: +44(0)1223-420561

Summary of content (2 pages)

PAGE 1
Lamp Grid R-52G Mineralight® UV Lamp The lamp has a special grid available only from UVP LLC. If broken, return the grid and reflector to the factory together to assure a proper fit when the new grid and reflector are returned. Remove the filter frame as described above. Then, remove the five screws from the lower housing. Unscrew the two wire nuts. Remove the four screws holding the reflector to the lamp housing. Pack the tube and reflector carefully to decrease the chance of breakage.
PAGE 2
Introduction Lamp Housing Your new R-52G lamp represents the highest achievement in ultraviolet lamp history. The result of extensive research and craftsmanship, this lamp will give you years of trouble-free service. All R-52G lamps are constructed of hand-contoured, ® rugged Cycolac plastic and use a shortwave, 254nm lamp grid. To remove the lamp housing from the transformer handle, grasp the top of the transformer with the right hand.