Technical information

4 Setting Up (Transmitter and Dive Computer)

II Uwatec

Aladin

Air Z

3.Open the tank valve. The transmitter briefly sends a pairing sequence to the

computer.

4.The dive computer shows a flashing <PAIr> in the display-position of tank pres-

sure shortly after the valve has been opened.

5.In order to confirm the pairing the B- and E- contacts have to be bridged. A bleep

confirms the input and <PAIr> is displayed permanently. The computer and trans-

mitter must remain in physical contact until the confirmation has been done.

6.Tank pressure is displayed after approximately 10 seconds.

7.In case of faulty pairing, the display <FAIL> appears instead of <PAIr>. In that

case, completely depressurise the regulator and repeat the pairing procedure.

This is only possible after at least 15 seconds.

– Pairing of transmitter and dive computer remains valid until a new pairing pro-

cedure is carried out. Pairing of transmitter and dive computer can therefore be

carried out at home and need only be executed once, before the first use. A

new pairing procedure is always necessary when a new transmitter or a new

dive computer is used and after changing the battery.

– Tank pressure shown in the lower part of the display of the dive computer

should be checked prior to every dive.

tank data

bar

10 s

tank data