User manual

16
ALADIN SQUARE USER MANUAL
1.0.19 Setting the UTC
UTC setting will change the shown time
compared to Greenwich 0-Meridian. This
feature is practical when traveling through
different time zones.
By pressing SEL at UTC menu, the hours
will start blinking. You may edit them in
range of -13..+14 hours by pressing right
or left. By pressing SEL the minutes will
start blinking and you may edit them in 15
minutes steps by pressing right or left. By
pressing SEL will save the UTC setting.
1.0.20 Setting the time
In set time menu the current time is shown
on the menu. By pressing SEL the time
setting will be activated and hours start
blinking. You may change the hours by
pressing right or left. By pressing the SEL
the minutes start blinking and you may
now edit them by pressing right or left. By
pressing SEL the new time will be set.

NOTE: seconds cannot be edited;
they always start counting from 0
when minutes are con rmed by
pressing SEL.
1.0.21 Set the AM/PM or 24h mode
By pressing SEL at the time mode menu
the numbers 24h or alternatively AM/
PM start blinking. By pressing right or left
you may change between the modes. By
pressing SEL the mode will confi rmed.

NOTE: the AM/PM selection will
change the day format to following:
Month.Date.Year. This change takes
place in main time & date display and
in dive computer log book.
1.0.22 Setting the date
By pressing SEL at the date menu the
fi rst two digits of the day/month fi eld start
blinking and they can be changed by
pressing right or left (in 24h mode the fi rst
digit is days, in 12h mode the month is
fi rst). Pressing SEL will confi rm the setting
and next two digits start blinking. Again, by
pressing SEL these are confi rmed and the
year will start blinking. By pressing right or
left the year can be edited. By pressing SEL
the year will be confi rmed.