User manual

28
ALADIN SQUARE USER MANUAL
If you decide to change between modes
before the 48h interval or full desaturation
you have to go to desaturation reset menu
and make a manual desaturation reset.
By pressing the SEL at this menu the mode
starts blinking. By pressing right or left you
may select between SCUBA, gauge or
apnea modes. By pressing SEL the setting
is confi rmed.
1.7 HR enable
By pressing SEL at this menu the HR
function starts blinking and by pressing right
or left you may select between on or off.
By pressing SEL the setting is confi rmed.
2. SQUARE AS A DIVE
COMPUTER
Square is a full-featured diving computer,
capable of multigas decompression
calculations, ascent rate calculations
and warnings. The logbook can store
about 50 hours of dive profi les with a 4s
sampling rate. During diving it displays
depth, dive time, decompression status,
water temperature and much more. On the
surface after a dive, remaining desaturation
time, no-fl y time, surface interval and
prohibited altitude classes are shown.
2.1 Diving with Square
The functions of the buttons during diving
are summarized in the table below.
Note that Square can be set to three dive
modes: Scuba, Apnea and Gauge. Due to
the operation differences also buttons have
different functions.