User manual

39
English
ALADIN SQUARE USER MANUAL
Depth: the depth is given in 10cm resolution
when metric mode. When the depth is
displayed in feet, the resolution is always 1
foot. At a depth shallower than 0.8m/3ft,
the display shows --. Maximum possible
depth is 120m/394ft.
No-stop time: calculated in real time and
updated every 4 seconds. Maximum
displayed no-stop times is 99 minutes.
WARNING:
During all dives, perform a safety stop between
3 and 5 meters/10 and 15 feet for 3 to 5 minutes,
even if no decompression stop is required.
Temperature: Square displays the water
temperature during the dive and the air
temperature on the surface. However,
the skin temperature infl uences the
measurement when worn at the wrist.
Decompression information: when Square
calculates the need for a mandatory
decompression stop, it shows you how
long and how deep your deepest stop is. It
also gives you the total ascent time. Stops
deeper than 27m/90ft and total ascent times
longer than 99 minutes are shown as “- - “.
Decompression information at MB L0: if you
are diving with an MB level different than
MB L0, you can ask Square to show you
the decompression information pertinent to
the underlying MB L0 calculation. For more
information on MB levels, please refer to
chapter Diving with MB levels.
2.7.1 Display con guration during
the dive
Throughout the dive, Square displays the
current depth (top row left), the elapsed dive
time (bottom row left) and the no-stop or
decompression information (top row right).
In addition, Square utilizes the alternate
displayed data at middle and bottom row
right regarding the dive. By pressing right
button will show, in sequence:
1. PDIS depth (when pending)
2. Maximum depth (only if 1m/3ft ascent
detected)
2. Water temperature
3. Heart rate (if activated)
4. O
2
%
a. MOD of the active gas (if gas d enabled)
b. If gas 1 active then bail out info using
only gas 1 at the middle row
c. Active MB level
d. No-stop or decompression information
at L0 (displayed in middle row, only if
diving with an MB level other than L0)
5. CNS % if greater than 1%
6. Time of the day in the bottom row for 5
seconds (temperature at bottom row right).
2.7.2 Setting bookmarks
By press and hold LIGHT button you can
set any number of bookmarks as reminders
of particular moments during the dive. The
bookmarks will appear on the dive profi le in
LogTRAK.
NOTE: If the “stop watch” counter has
been enabled the long press left will
activate it.