Technical information

3. Meridian as a dive computer
3. Meridian as a dive computer
31
English
SCUBAPRO MERIDIAN
may change the value between 1000 and
1050 gram/liter (58417..61339 Grains/
gallon). By pressing the SEL/ESC button
the value is confirmed.
Water density
3.5 Algorithm selection
You may select your Meridian operation
mode between SCUBA, GAUGE and
APNEA modes.
When Meridian has not been submerged
for a while the display will appear as follows:
By pressing the SEL/ESC button at this
menu the mode starts to flash. By pressing
the +/UP or –/DOWN button you may
select between SCUBA, GAUGE and
APNEA modes. Pressing the SEL/ESC
button will confirm the selection.
Since the GAUGE and APNEA modes
are not tracking the tissue saturation,
there is a 48 h locking interval after the
last dive in GAUGE or APNEA mode
before change to a SCUBA mode is
possible.
Meridian shown below has been dived in
GAUGE mode and the NO CHANGE lock
is still on for another 4 hours.
From the last SCUBA dive the change to
GAUGE or to APNEA mode is possible only
after the desaturation time has elapsed.
If you decide to change between modes
before the 48 h interval or full desaturation
you must go to the desaturation reset menu
and make a manual desaturation reset.
WARNING
Changing ALGO with remaining saturation
could lead to injury or death.