User Guide

• Avoid using the product after a dramatic change in temperature.
• When you move the product between environments with very different temperature and/or humidity ranges, condensation may form on or within the
product. To avoid damaging the product, allow sufficient time for the moisture to evaporate before using the product.
• Notice: When taking the product from low-temperature conditions into a warmer environment or from high-temperature conditions into a cooler
environment, allow the product to acclimate to room temperature before turning on power.
General precautions
• Use only accessories approved for use with the product. Do not connect with incompatible products or accessories.
• Protect the product. Always treat the product and its accessories with care.
• Do not use near a heater, fireplace, direct sunlight, air conditioning unit or other source of direct energy.
• Do not expose product to liquid.
• Do not use the product in any potentially explosive atmosphere or where flammable materials exist.
• Do not attempt to open, take apart or otherwise disassemble this product or its accessories.
• Keep product in a clean and dust-free place.
• Do not expose the product or its accessories to open flames or lit smoking products.
• Do not drop, throw or bend the product or its accessories.
• Do not paint or apply any coating to the product or its accessories.
• Store the product and its accessories at temperatures between 0°C to 40°C
• Avoid dropping the product headset or controllers. If dropped, especially on a hard surface, and the user suspects damage, take it to a service center for
inspection.
• Please check local regulations for disposal of electronic products
• Never push objects of any kind into slots or other openings in the product. Slots and openings may be provided for ventilation. These openings must not be
blocked or covered.
• If the product becomes uncomfortably warm during use, stop and allow it to cool down before continued use to avoid discomfort, redness, or low temperature
burns.
• If there is any itching, eczema, swelling, irritation of the skin, or you experience any discomfort, please discontinue use and consult your physician.
Faulty and damaged products/Service
• If user suspects damage or identifies signs of overheating, stop use and return product to a service center for inspection.
• If the product is exposed to liquid or excessive heat or does not operate normally when you follow the operating instruction, stop use and return product to a
service center for inspection.
• Do not attempt to disassemble or service the product or its accessories. Only qualified personnel must service or repair the product or its accessories.
• Do not use a damaged product as personal injury or further damage may result.
Cleaning the product
Unplug the product from its power source before cleaning. Use a soft damp cloth for cleaning, but NEVER immerse the product in water or cleaning solutions. Do not use
harsh chemicals, cleaning solvents, liquid cleansers or aerosols to clean the product or its accessories.
About Add-On Cover regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2Q6L300.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 2Q6L300
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12 Volts DC, maximum 2.5 Amp power supply unit.
Radio Frequency exposure
For body worn operation, this device has been tested and meets FCC and ISED RF exposure guidelines when used with an accessory that contains no metal. Use of other
accessories may not ensure compliance with FCC and ISED RF exposure guidelines.
To comply with the FCC and ISED RF exposure compliance requirements, this device and its antenna must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclaration de l'exposition aux radiations RF:
Pour une utilisation sur le corps, cet appareil a été testé et respecte les directives sur l'exposition aux RF lorsqu'il est utilisé avec un accessoire sans métal.
L'utilisation d'autres accessoires peut ne pas garantir la conformité aux directives d'exposition aux RF.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Déclaration d’interférences de la Federal Communication Commission
Le produit a été testé et s’est révélé conforme aux limites définies pour un appareil numérique de classe B, conformément à la section 15 des règles de la FCC. Ces limites
sont conçues pour offrir une protection raisonnable contre les interférences nuisibles dans un environnement résidentiel. Cet équipement génère, utilise et peut émettre de
l'énergie sous forme de fréquences radio et, s’il n’est pas installé et utilisé conformément aux instructions, peut provoquer des interférences nuisibles sur les interférences
radio. Cependant, il n’est pas garanti que des interférences ne se produiront pas dans une installation particulière. S’il s’avérait que cet équipement génère des interférences
nuisibles aux réceptions de radio ou de télévision, ce qui peut être vérifié en allumant et en éteignant l’équipement, l’utilisateur est encouragé à essayer de corriger les
interférences de l’une ou de plusieurs des manières suivantes.
• Réorientez ou déplacez l’antenne de réception.
• Éloignez l’équipement du récepteur.
• Connectez l’équipement à une prise fonctionnant sur un circuit différent du circuit auquel le récepteur est connecté.
• Demandez conseil à votre revendeur ou technicien spécialisé en radio/TV.
Avertissement de la FCC : Tout changement ou modification qui n’a pas expressément été approuvé par la partie responsable de la conformité annule l’autorité de
l’utilisateur à opérer l’équipement.
Cet appareil est conforme à la section 15 des règles de la FCC. L’exploitation est autorisée aux deux conditions suivantes : (1) Cet appareil ne doit pas causer d’interférences
nuisibles, et (2) doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable.
Cet émetteur ne doit pas être placé ou opéré conjointement avec une autre antenne ou un autre émetteur.
Innovation, Science and Economic Development Canada Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.