User's Guide
Handheld Temperature Probe
©2019 V-Mark. All rights reserved
V-Mark is a trademark of V-Mark Enterprises, Ltd. CONFIDENTIAL
Handheld Temperature Probe
VRKRTS03WREG01
The Handheld Temperature Probe is developed to perform a
manually triggered temperature measurement activity of the
desired zone or touched product. By pushing the button, the probe
will be activated and start the measurement. After 5 seconds of
stabilized contact, the temperature figure collected will be send to
the server using IEEE 802.15.4 communication protocol.
Users make the probe tine in contact with the desired
temperature zone to be measured.
Automatically reports temperature data collected to the server
wirelessly.
Rounded bottom to eliminate safety issue with the pointed tip.
2 LED Light pipes for work indications.
Transparent window on opposite side of the button for ID tag.
Features:
IEEE 802.15.4 communication
ABS handheld part
304 Stainless steel probe part
Silicon rubber push button
IP67 standard of protection
2 triple-A’s batteries
o Standby 1-year product life
Accessories Included:
User guide
Specifications:
Status Indicators (LEDs):
o All LED indicators shine through the plastic cover
o 3 color RGB indicating different status
Communications:
o IEEE 802.15.4
Measurement Range:
o -40 to 105 ℃ Measuring Range
o -40 to 85 ℃ storage
Measurement Accuracy：
o ±0.5 ℃
RF emissive (transmissive) power and sensitivity
o TX: +4.5dbm
o RX: -97dbm
Appearance characteristics:
Size: Handheld part dimension: L235 * W36.85 * H27.56 mm.
Weight: 70 grams w/ battery; 50 grams w/o battery.
Third party certification:
Safety:
NSF
Wireless device (class B device):
FCC
V-Mark
400-601 West Broadway, Vancouver
British Columbia, Canada
www.v-mark.com
+1 (604) 588-6178
All registered trademarks and trademarks are property of their respective
owners.
Copyright 2020 V-Mark. All rights reserved. Patents granted and pending.
©2020 V-Mark Enterprises, Ltd. All rights reserved.
The information in this document is believed to be accurate and reliable.
However, V-Mark assumes no responsibility for the consequences of use of
such information. Specifications in this publication are subject to change
without notice. Company products are not authorized for use as critical life
support systems.
FCC Warnning:
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.