User manual

- 6 -
The external 4 wires of TLT-1BGPS/GSM tracker are as follows. Red for the 12V power wire,
connect to the car battery anode; Black for the earth, connect to the car battery cathode; Yellow for
the SOS for help Control wire, connect external SOS switch button to car battery cathode; Purple
for cut-off oil and power control wire, connect to the relay coil 86, i.e. one end. Relay 85, i.e. anther
end connects to oil and power supply 12V. 30, 87a are normal closed-end, series in the oil and
power supply circuit. Please note that if the installation of lead wire is right, if errors installation led
to the equipment damage, At Own Risk, the company is not responsible for it.
Specific Application
When you read the brief description of the product, the product has been installed,
SIM card already installed. Start following a specific use.
First step, a product owner, stored telephone numbers, and only had phone numbers
stored, the product will send you instructions to respond to other messages in order
to work properly. Products of the factory configured in the appendix. Command as
follows:
Instruction format ： * New number 4-20 bit * Password 4 * number (1-3) **
For example: * 13900000000 * 0000 * 1 **
Note: User initial password is: 0000. TLT-1B can be stored up to three phone numbers.
When the TLT-1B receiving the order, confirm the user password is correct with the
new number to replace the existing number, after the success of the sender to send
the confirmation to the "SET USER NUMBER (1-3) OK".
1. Mode
Mode
Mode
Mode of
of
of
of introduction
introduction
introduction
introduction of
of
of
of products
products
products
products
The product has two modes of the SMS point to point mode and GPRS online mode, the
user would like to use if necessary, read the vehicle with a mobile phone (ie products)
latitude and longitude, map, check with the Internet, by phone control to control
vehicle oil road leads off the point to point can be selected messages; required
dynamic real-time monitoring of vehicles can use GPRS real-time online mode.
Switching modes are as follows:
2 Based on the general application of SMS Point to Point
The product's default mode is SMS point to point mode, do not switch; if from the
GPRS mode to switch to point mode, press the 2.1.0 operation.