Manual

2.2.6 IP Address Setup
1. General Rules for IP Adress Setup
2. IP Address Setup by IP8210 Cong Software
ForconstructingaDEDICATEDLANforIPsystem,allnetworkdevicesmustbespecied
different IP Address.
* Network device model includes DT-IPC, CM-IPC, IP-G21 and PC Station.We will just
state device short for network device in the following statement.
*Allnetworkdevicecanbe detectedby IP8210 cong andIP-Device,butonlyDT-IPC,
CM-IPC & IP-G21 can be set by the two softwares. PC Station is set by Windows IP setup
All the devices must be in the same IP Segment.(Assume that using the segment:
192.168.0.X in this manual )
* 192.168.0.1 is used as a network gateway. Devices can’t be set to this address
* All devices must be set a unique IP address & MAC address
* If more than one device have the same IP address, only one of them can be available
byIP8210congorIP-Devicesoftware
* If PC & the device to be set have the same IP, the device can’t be detected by IP8210
congorIP-DevicesoftwareinthisPC.
* Here are the table for range of device IP address
Range: Device:
192.168.0. 2 – 192.168.0. 240 DT-IPC, CM-IPC
192.168.0.241– 192.168.0.246 PC Station(IP-Agent)
192.168.0.247 – 192.168.0.254 Guard Station(IP-G21)
For new devices, IP address of devices are initialized to the same address, so it’s
recommendedthatIPaddressofdevicesissetonebyone.It’seasilyfullledviaIP8210
Congsoftware.
-27-
IP-2 wire system technical guide