Operating instructions AiroClearCabinet V4000 Range hood
Thank you for choosing to buy one of our products. Your appliance is made to high standards and is easy to use. Nevertheless, please take the time to read these operating instructions in order to familiarize yourself with the appliance and get the best use out of it. Please follow the safety precautions. Modifications Text, diagrams and data correspond to the technical standard of the appliance at the time these operating instructions went to press.
Contents 1 Safety precautions 4 1.1 Symbols used......................................................... 4 1.2 General safety precautions.................................. 4 1.3 Appliance-specific safety precautions ............... 5 1.4 Appliance installation ............................................ 6 1.5 Instructions for use................................................ 6 2 Appliance description 2.1 Introduction ............................................................. 8 2.
1 Safety precautions 1.1 Symbols used Denotes important safety precautions. Failure to observe said precautions can result in injury or in damage to the appliance or fittings! Information and precautions that should be observed. Information on disposal Information about the Operating Instructions Remove plug from mains socket / disconnect power supply Insert plug into mains socket / connect power supply Do not cut off or modify mains plug Wear protective gloves ▸ Indicates step-by-step instructions.
1 Safety precautions turer or its Customer Services or a similarly qualified person in order to avoid hazard. 1.3 Appliance-specific safety precautions ▪ The room must be adequately ventilated when operating the range hood at the same time as other appliances that burn gas or other fuels. ▪ Observe the official regulations for the exhaust-air layout. ▪ The extracted air must not be fed into a chimney which is used for exhausting fumes from appliances burning gas or other fuels.
1 Safety precautions 1.4 Appliance installation 1.5 Instructions for use Before using for the first time ▪ The appliance must be installed by qualified personnel only. ▪ Each step must be carried out and checked in full in the order specified. ▪ Electrical connections must be carried out by qualified personnel in accordance with the guidelines and standards for low-voltage installations and the specifications of the local electricity supply companies.
1 Safety precautions Note on use Caution: Burns hazard! ▪ If the appliance is visibly damaged, do not use it. Contact our Customer Services. ▪ If the appliance is not functioning properly, disconnect it from the power supply immediately. ▪ Ensure there is adequate ventilation when the extractor fan is on so as to avoid creating underpressure in the kitchen and to achieve optimal air extraction. ▪ Avoid a cross-current of air, which could blow the cooking vapours over the cooking area.
2 Appliance description 2.1 Introduction The appliance is designed for use in the home for extracting cooking odours from above a cooking area and can be used in the extraction or recirculation mode. Extraction mode 2.2 Recirculation mode Extraction mode A fan extracts cooking fumes and smells from above the cooking surface.
3 Operating the appliance 2.6 Operating and display elements Switch illumination on/off; set colour temperature Switch appliance on/off Power level 1 Power level 2 Power level 3 and intensive level (flashing) Activate after-running time Saturation indicator for metal grease filter (flashing) Saturation indicator for activated charcoal filter (flashing) Depending on the model and features, the specification of your appliance may differ in individual details from the standard specification described.
3 Operating the appliance Cleaning interval for the activated charcoal filter Cooking intensity Saturation indicator after Flashing display symbol Less frequent and/or light cooking aromas 240 hours + Standard (factory default setting) 180 hours + Frequent and/or strong cooking aromas 120 hours + Setting up the appliance for use in the extraction mode If the appliance is to be operated as an extraction model, the saturation indicator for the activated charcoal filter must be deactivated.
3 Operating the appliance Intensive level The intensive power level runs for 5 minutes. It is used for short bursts of intensive extraction of cooking fumes and smells, e.g. when searing meat. The intensive power level then switches back to the previously selected power level or switches the appliance off. ▸ Touch the button and switch the appliance on. ▸ Hold the button depressed for 2 seconds. – The appliance switches to the intensive power level and the LED for the button flashes.
3 Operating the appliance Leave the appliance running for a few minutes after cooking so as to extract all the cooking smells. 3.6 Saturation indicators Metal grease filters The LED for the button flashes after 20 operating hours. The saturation level has been reached and the metal grease filters must be cleaned. Activated charcoal filter (recirculation mode only) The LED for the button flashes after 120, 180 or 240 operating hours, depending on the cleaning interval set.
3 Operating the appliance ▸ If a connection could be established, this must be confirmed on the hob. See the operating instructions for the hob for this. The buttons and operating elements on the range hood are deactivated during the connection process. A range hood may be connected to as many as three hobs. And a single hob may be simultaneously connected to several range hoods. Establishing a connection requires appliances are equipped with OptiLink.
3 Operating the appliance The range hood illumination is on – irrespective of whether the fan's after-running time function is running – and goes off within 5 minutes of the hob being switched off. This allows enough time for plating up the food. The display symbol illuminates when after-running time is active.
3 Operating the appliance Activating the remote control ▸ Switch the appliance and the illumination off. ▸ Hold the button and on the appliance depressed for 4 seconds. – The LED for the button flashes for 30 seconds. ▸ Press any button on the remote control to confirm. – The LED for the button stops flashing. – The appliance can now be operated using the remote control. Deactivating the remote control ▸ Switch the appliance and the illumination off.
4 Care and maintenance 4 Care and maintenance 4.1 Cleaning the housing Make sure no water gets inside the appliance. If water gets into the appliance, it can cause damage. Do not use abrasive cleaners, scouring pads, steel wool, etc. for cleaning, as they can damage the surface. Disconnect the power supply before cleaning. Exterior ▸ Clean using a clean, damp cloth and a mild detergent, then wipe dry. Interior Grease and condensate water can build up on the inside around the metal grease filters.
4 Care and maintenance 4.3 Long-life-Plus activated charcoal filter The long-life-Plus activated charcoal filter should be cleaned and regenerated every 3 to 6 months with normal use and whenever the saturation indicator alarm is triggered. Depending on intensity of use, do not exceed 5–8 regeneration cycles. If properly cared for, the service life of the long-life-Plus activated charcoal filter is up to three years. Switch off the power supply to the appliance.
5 Trouble-shooting 4.4 Reset saturation indicator alarm Reset the saturation indicator alarm for both the metal grease filter (LED for button flashes) and the activated charcoal filter (LED for button flashes) after cleaning/replacing. ▸ Hold the button depressed for 5 seconds. – If reset successfully, the LED for the or button will stop flashing. 4.5 Replacing the LED light bulbs For safety reasons, the LED light bulbs must be replaced by our Customer Services.
6 Accessories and spare parts 6 Accessories and spare parts Please give product family of the appliance and exact designation of the accessory or spare part when ordering parts. Metal grease filter (example is shown; actual filter depends on model) Long-life-Plus activated charcoal filter Remote control 7 Technical data Electrical connection Accessing the identification plate: ▸ Remove the metal grease filters. ▪ The identification plate is located on the inside of the appliance.
7 Technical data 7.2 Product fiche In accordance with EU Regulation No. 65/2014 and No. 66/2014. Description Brand Model identifier Abbreviations Unit Value S - V-ZUG LTD M - 64009 / 64010 Annual Energy Consumption AEChood kWh/a 43.9 / 43.9 Energy Efficiency Index EEIhood % 46.4 / 46.4 Energy Efficiency Class EEC - A/A Fluid Dynamic Efficiency FDEhood % 33.1 / 33.1 Fluid Dynamic Efficiency Class FDEC - A/A Lighting Efficiency LEhood lux/W 42.2 / 42.
8 Disposal Average illumination of the lighting system over the cooking surface Sound power level 8 Disposal 8.1 Packaging Emiddle lux 168.9 / 168.9 Lwa dBA - Never allow children to play with packaging material due to the danger of injury or suffocation. Store the packaging material in a safe location or dispose of it in an environmentally-friendly way. 8.2 Safety Render the appliance unusable to prevent accidents caused by improper use (e.g.
9 Index A S Accessories ...................................................... 19 After-running time............................................. 11 Appliance configuration..................................... 9 Appliance description ........................................ 8 Appliance disposal .......................................... 21 Appliance installation ......................................... 6 Safety precautions Appliance-specific ..........................................
10 Service & Support 10 Service & Support The «Trouble-shooting» section gives you valuable tips on how to deal with minor malfunctions yourself, saving you the time and trouble of calling out a service technician and any cost that goes along with it. Information on the V-ZUG warranty can be found at www.vzug.com →Service →Warranty information. Please read this information carefully. Please register your V-ZUG appliance straightaway: ▪ online at www.vzug.
Quick instructions Switch illumination on/off; set colour temperature Switch appliance on/off Power level 1 Power level 2 Power level 3 and intensive level (flashing) Activate after-running time Saturation indicator for metal grease filter (flashing) Saturation indicator for activated charcoal filter (flashing) 1087959-R02 V-ZUG Ltd, Industriestrasse 66, CH-6302 Zug Tel. +41 58 767 67 67, Fax +41 58 767 61 61 info@vzug.com, www.vzug.com Service Centre: Tel.
