Operation Manual

4 Care and maintenance
17
4.3 Replacing the standard activated charcoal filter
Standard activated charcoal filters are only used in the recirculation model.
The standard activated charcoal filter is to be replaced after an operating time
of 3 to 6 months. Activated charcoal filters cannot be washed or regenerated.
➤ Remove both metal grease filters 1.
➤ Press the two red retaining slides 2 on the standard activated charcoal
filter 3 upwards. At the same time pull down the filter and remove from the
holder 4.
➤ Slide the new filter up under the clip and secure in the fixture 4. To do this,
snap the red retaining slides 2 into place.
➤ Put both metal grease filters 1 back in.
➤ Put the screw fuse back in or switch the circuit breaker on again.
Remove the screw-in fuse for the appliance or switch off the circuit
breaker.
The spent standard activated charcoal filter can be disposed of in the
household waste.
3
2
3
2
4
1