User Manual

7 Trouble-shooting
Display Possible cause Solution
Hygiene recom-
mend.
▪ No wash cycle has been
carried out at a temperat-
ure of at least 60 °C for
a longer period of time.
▸ With one of the next wash cycles carry
out a wash with at least 60°C.
Or:
▸ Run «Appliance hygiene» programme
without laundry (see page 20).
Inlet water very
cold:
Heating extended
▪ Inlet water is very cold.
Heating is extended.
▸ No action is necessary.
Too many items:
Heating extended
▪ The selected programme
is intended for a smaller
load. Heating and pos-
sibly rinsing is extended.
▸ Adjust load to the max. load size (see
page 12).
Large unbalanced
load:
Spin extended
▪ The appliance optimizes
the distribution of the
wash load to com-
pensate an unbalanced
load. The final spin is ex-
tended.
▸ Wash large and small items together
to avoid large unbalanced loads.
7.2 Other possible problems
Problem Possible cause Solution
The washing has
not been spun or
has been spun in-
sufficiently.
▪ The spin speed set is too
low.
▸ Increase the spin speed for the next
wash cycle (see page 23).
▪ Too large an unbalanced
load in the washing
drum.
▸ Wash large and small items together.
▪ «Steam anti-crease» was
selected and the appli-
ance was not standing
level.
▸ Optimize appliance set-up according
to installation instructions.
The appliance vi-
brates heavily when
spinning.
▪ The transport lock has
not been removed.
▸ Remove transport lock (see page 4).
▪ The feet of the appliance
are not properly adjus-
ted.
▸ Set appliance feet so that the appli-
ance stands level.
▪ The load could not be
optimally balanced in the
washing drum.
▸ Wash large and small items together.
33