User Manual

Phono: Selects between the MM and MC inputs. Overall phono function is selected

with the main Selector switch (phono is one click counterclockwise from “1”

or one click clockwise from “6”).

PH1 is the MC phono input. It has 64 dB of gain, making it suitable for most

low output cartridges.

PH2 is the MM input, which provides 44 dB of gain, suitable for use with MM

(moving magnet) and many high-output MC (moving coil) cartridges.

Optionally, PH2 may be a second MC input.

Both PH1 and PH2 may be connected in the same system, so that in essence

there are two phono inputs, selectable from the front panel.

Selector: This switch selects between IN1 through IN6 and the PHONO inputs. Rotate

counterclockwise to move down through the inputs, clockwise to move up

through the inputs.

Volume:Controls the output level for the PHONO input, and any line input set to the

“VAR” LEVEL mode. Note: it is possible that one or both channels may not

shut off completely in the fully counter-clockwise position, and that channel

balance may skew at whisper levels.

Meters: Indicate the operating voltages within the unit. This will vary somewhat due

to fluctuations in power line voltage.