Manualshelf

Use and Care Manual

ManualsBrandsVacmaster ManualsToolsProfessional 20-Volt 4 Gal. Cordless Jobsite Wet/Dry Vac
11121314151617181920
14
MAINTENANCE
INFLATOR NOZZLE ADAPTER OPERATION
WARNING!
To reduce the risk of injury, always unplug the charger and
remove the battery pack from the charger or tool before performing any maintenance.
Never disassemble the tool, battery pack or charger.
IMPORTANT!
BEFORE CLEANING YOUR VACUUM OR CARRYING
OUT ANY MAINTENANCE, MAKE SURE THAT THE TOOL IS SWITCHED OFF AND
POWER SUPPLY DISCONNECTED TO PREVENT ACCIDENTAL START-UP.
1. Connect the hose to the blower port (Fig. 20).
2. Push required accessories onto the free end of the hose or the extension wand (Fig. 21).
3. Make sure the battery is correctly installed (Fig. 22). For installation instructions see page 10.
4. Turn the motor on by ipping the switch to the 'I' ON position (Fig. 23).
5. Once you have completed blowing, turn the motor off by ipping the switch to the 'O' OFF
position (Fig. 24).
6. Remove the battery and place it in the storage bay (Fig. 25).
26 27
INFLATING AN OBJECT
The included inator nozzle adapter allows any wet/dry vacuum with a blower function to be used
to inate items such as air mattresses and recreational oatation devices. These nozzles can also
be used to focus the air ow, allowing for more concentrated blowing.
1. Make sure the collection tank is empty before using the wet/dry vacuum to inate.
2. Connect the hose to the blower port.
3. Push the desired inator nozzle onto the adaptor, then connect to free end of the hose (Fig. 26).
4. Make sure the battery is correctly installed. For installation instructions see page 10.
5. Insert the inator nozzle into the air valve of the item being inated (Fig. 27).
6.
Turn the motor on by ipping the switch to the 'I' ON position. Once you have completed inating,
turn the motor off by ipping the switch to the 'O' OFF position.
7. Remove the battery.
DEFLATING AN OBJECT
1. Connect the hose to the vacuum port (Fig. 13).
2. Push the desired inator nozzle onto the adaptor, then connect to free end of the hose (Fig. 26).
3. Make sure battery is correctly installed. For installation instructions see page 10.
4. Insert the inator nozzle into the air valve of the item being deated.
5.
Turn the motor on by ipping the switch to the 'I' ON position. Once you have completed deating,
turn the motor off by ipping the switch to the 'O' OFF position.
6. Remove the battery.