Use And Care Manual

LED WORK LIGHT USE

When vacuuming in a dark room or in the corner of a fireplace or stove, the LED Work Light can help shed

some light on the work area.

Attach the LED Work Light to the crevice tool or wand with the included hook and loop strap, and switch it on

when you need more light. (Fig. 1 & Fig. 2)

There are two replaceable button cell batteries in the LED Work Light. You can change them by yourself

when the LED is turned off.

1. Insert the screwdriver into the slot on both sides of battery cover (Fig. 1) and remove the battery cover.

2. Carefully replace both button cell batteries with a new set of batteries. (Fig. 2)

3. Close the cover by pressing the cover into the LED work light housing with proper force. (Fig. 3)

4. Check if the battery cover is closed and the light turns on and off.

Use only a CR 2016 3V button cell battery with your LED Work Light.

Use a properly size of slotted screwdriver to open the battery cover.

CAUTION! This product contains a button battery. If swallowed, it could cause severe injury or

death in just 2 hours. Seek medical attention immediately!