Wet/Dry Vacuum Operator’s Manual 5 Gallon Model No. VFB511B 0201 FOR YOUR SAFETY Read and understand this manual before use. Keep this manual for future reference. Distributed By Cleva North America, Inc. 601 Regent Park Court Greenville, SC 29607 Replacement Filters & Accessories available at: Vacmaster.
TABLE OF CONTENTS SECTION PAGE Warranty............................................................................................................................................ 2 Safety Instructions & Warnings......................................................................................................... 3 Double Insulation Instructions........................................................................................................... 4 Extension Cords...................................
SAFETY INSTRUCTIONS & WARNINGS IMPORTANT SAFETY INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS VACUUM. Read and understand this operator's manual and all labels on the Wet/Dry Vacuum cleaner before operating. Safety is a combination of common sense, staying alert, and knowing how your vacuum works. Use this Wet/Dry Vac only as described in this manual. To reduce the risk of personal injury or damage to your Wet/Dry Vac, use only Vacmaster ® recommended accessories.
DOUBLE INSULATION INSTRUCTIONS This Wet/Dry Vac is double-insulated, eliminating the need for a separate grounding system. Use only identical replacements parts. Read the instructions for Servicing Double-Insulated Wet/Dry Vacs before servicing. Use this Wet/Dry Vac as described in this manual. Observe the following warnings that appear on the motor housing of your Wet/Dry Vac. DOUBLE INSULATED - GROUNDING NOT REQUIRED - WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
UNPACKING & CHECKING CARTON CONTENTS Remove all contents from the box. Remove the power head and take out any contents inside the collection tank. Check each item against the carton contents list. A B Carton Contents List: C D E F G H I J K L M N Wet/Dry Vacuum Key A B C D E F G H I J K L M N Description..........................................Qty. Vac Assembly..........................................1 Filter Basket............................................1 Handle Assembly..............
GENERAL ASSEMBLY INSTRUCTIONS A Philips head screw driver is required. 1 2 3 4 5 6 7 8 9 10 11 12 1 2 13 14 15 UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY 1. Verify that the power cord is disconnected from the outlet. (Fig. 1) 2. Undo the latches. (Fig. 2) 3. Lift the power head off the collection tank. (Fig. 3) 4. Remove the contents from inside the collection tank; make sure you have all contents as listed on page 5. (Fig. 4) 5. Your vacuum comes ready for dry vacuum cleaning.
DRY VACUUM OPERATION 1 2 4 3 5 6 7 DRY VACUUMING WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER.
LIQUID VACUUM OPERATION 1 2 3 4 5 6 LIQUID VACUUMING WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OILBASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER.
BLOWER OPERATION 1 2 3 4 This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed. WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA, CSAZ94.3) BEFORE USING BLOWER. WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS. WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED. 1. 2. 3. 4. 5. 6. 7. 8. 9. Verify that the power cord is disconnected from the outlet. (Fig.
MAINTENANCE Emptying the Collection Tank 1 2 4 3 WARNING: MAKE SURE POWER CORD IS DISCONNECTED BEFORE CHANGING THE FILTERS. 1. 2. 3. 4. 5. 6. 7. Verify that the power cord is disconnected from the outlet. (Fig. 1) Disconnect the hose from the vacuum by turning in a counter clockwise direction. (Fig. 2) Undo the latches and remove the power head from the collection tank. (Fig. 3) Clear all dirt or debris from the collection tank and hose. (Fig. 4) Clean or replace the filters.
INSTALLING & CLEANING CARTRIDGE FILTER 1 2 3 4 5 6 Installing Cartridge Filter 1. Verify that the power cord is disconnected from the outlet. (Fig. 1) 2. Remove power head and place in upside down position. 3. Install the cartridge filter over the filter cage with the flat end of the filter towards the power head. Carefully push filter in until it stops against the power head. (Fig. 2 & 3) 4.
INSTALLING & CLEANING FOAM WET FILTER 1 2 3 4 5 Installing Foam Wet Filter 1. Verify that the power cord is disconnected from the outlet. (Fig.1) 2. Remove power head and place in upside down position. Follow instructions to remove cartridge filter. 3. Carefully slide foam wet filter down over the filter cage making sure the cage is completely covered. (Fig. 2 & 3) 4. Place the power head onto the collection tank. Cleaning Foam Wet Filter 1.
EXPLODED VIEW 13
PARTS LIST Part 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 Drawing Number 551253101 551013103 551013104 551012116 VJFF 551062108 551253104 551062104 551062105 551027140 551059111 551001121 551011109 551109125 551109126 VFF21 Description Handle Assembly Hose Holder Power Head Assembly Float Filter Cage Cartridge Filter Filter Retainer Latch Assembly Quick Release Cord Wrap Assembly Collection Tank Vacuum Port Assembly Noise Diffuser EVA Hose Extension Wands Utility Nozzle Crevice Tool Car Nozzle Foam Wet