Instruction Manual

19
INSTALLING & CLEANING CARTRIDGE
FILTER
3
4
1
2
5
8
6 7
INSTALLING CARTRIDGE FILTER
REMOVING & CLEANING CARTRIDGE FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in an upside-down position.
3. Install the cartridge lter over the lter cage making sure the cage is completely covered (Fig. 2
& 3).
4. Place the lter retainer on the top of the cartridge lter over the raised lip and tighten down by
turning the retainer clockwise; do not over-tighten (Fig. 4 & 5).
5. Place the power head back onto the collection tank.
1. Unlock and remove the lter retainer by turning the retainer handle counter-clockwise (Fig. 6).
2. With the removed power head in an upside-down position, carefully remove the cartridge lter
from the lter cage (Fig. 7).
3. Clean the cartridge lter by gently brushing or rinsing off the debris (Fig. 8). Cleaning should not
be done indoors in living areas. For optimal performance a new lter is recommended.
4. Install cleaned or new lter as described in steps 2-4 of Installing Cartridge Filter. Wet lter
should be removed and allowed to air dry for 24 hours before installing onto the lter cage.