Instruction Manual
21
CLEANING & REPLACING EXHAUST
FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Unlock the exhaust lter door by lifting the locking tab upwards to the release. Pull the door out
(Fig. 2).
3. Remove the exhaust lter from the vacuum and clean by gently tapping or brushing off dirt. For
optimal performance it is recommended to replace the old lter with a new lter regularly (Fig. 3).
4. Install the cleaned or new lter. Then insert the lter door tabs into the upper slots and lock the
lter door into place (Fig. 4).
3
4
1
2
CHANGING THE BATTERY
NOTE:
Only replace the battery with a 27A 12V Alkaline battery.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Pry off the battery cover and remove it from the battery compartment (Fig. 2).
3. Remove the battery from the battery compartment. Insert the new battery with the terminals in
the direction as shown (Fig. 3).
4. Position the battery cover in the angle of inclination as shown. Then insert it into the slot on the
battery compartment and press down the battery cover to click into place (Fig. 4 & 5).
3
4
1
2
5
+
+
-
+
+
-
I
II