Wet/Dry Vacuums Operator’s Manual Model No. VOC507S 1001 FOR YOUR SAFETY Read and understand this manual before use. Keep this manual for future reference. Distributed By Cleva North America, Inc. 601 Regent Park Court Greenville, SC 29607 Replacement Filters & Accessories available at: Vacmaster.
TABLE OF CONTENTS SECTION Warranty........................................................................................................................................ Safety Instructions and Warnings.................................................................................................. Double Insulation Instructions....................................................................................................... Extension Cords............................................................
SAFETY INSTRUCTIONS & WARNINGS IMPORTANT SAFETY INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS VACUUM. Read and understand this operator's manual and all labels on the Wet/Dry Vacuum cleaner before operating. Safety is a combination of common sense, staying alert, and knowing how your vacuum works. Use this Wet/Dry Vac only as described in this manual. To reduce the risk of personal injury or damage to your Wet/Dry Vac, use only Vacmaster® recommended accessories.
DOUBLE INSULATION INSTRUCTIONS This Wet/Dry Vac is double-insulated, eliminating the need for a separate grounding system. Use only identical replacements parts. Read the instructions for Servicing Double-Insulated Wet/Dry Vacs before servicing. Use this Wet/Dry Vac as described in this manual. Observe the following warnings that appear on the motor housing of your Wet/Dry Vac. DOUBLE INSULATED - GROUNDING NOT REQUIRED - WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
UNPACKING AND CARTON CONTENTS A Remove entire contents of carton. Remove the power head and take out any contents inside the collection tank. Check each item against the carton contents list. B C D J E F G H I K Key A B C D E F G H I J K Carton Contents List Description........................... Qty. Vac Assembly...........................1 Hose.........................................1 Extension Wand........................3 Floor Brush/Squeegee..............1 Utility Nozzle..................
GENERAL ASSEMBLY INSTRUCTIONS 1 2 3 4 5 6 7 8 WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC. GENERAL ASSEMBLY INSTRUCTIONS 1. Verify that the power cord is disconnected from the outlet. (Fig. 1) 2. Undo the latches and lift the power head off of the collection tank. (Fig. 2) 3. Remove the package contents from inside the collection tank. (Fig. 3) 4.
DRY-VACUUM OPERATION 4 5 6 7 DRY VACUUMING WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER.
LIQUID VACUUM OPERATION 5 6 LIQUID VACUUM CLEANING WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER.
BLOWER OPERATION 1 2 6 7 3 4 5 This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed. WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA, CSAZ94.3) BEFORE USING BLOWER. CAUTION: WARNING: BE INHALED. KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS. WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed below: 1.
CARE AND MAINTENANCE 1 1. 2. 3. 4. 5. 6. 2 4 3 5 Verify that the power cord is disconnected from the outlet. (Fig. 1) Disconnect the hose from the vacuum. (Fig. 2) Undo the latches and remove the power head from the collection tank. (Fig. 3) Clear all dirt or debris from the collection tank and hose. (Fig. 4) Clean or replace the filters. (Fig. 5) Check the hose, attachments, and power cord to verify that they have not been damaged.
INSTALLING AND CLEANING REUSABLE CLOTH FILTER 1 2 3 4 Installing Reusable Cloth Filter 1. Verify that the power cord is disconnected from the outlet. 2. Remove power head and place in upside down position. 3. Slide reusable cloth filter down over the filter cage making sure the whole cage is covered. (Fig.1 & 2) 4. Replace the power head on to the collection tank. Removing and Cleaning Reusable Cloth Filter 1.
TROUBLESHOOTING WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING Symptom Vacuum will not operate. Possible Causes 1) No power supply. 2) Faulty power cord. Corrective Action 1) Check power supply – cord, breakers, fuses. 2) Unplug and check the power cord. If damaged, have it repaired by a professional. 3) Empty collection tank. 1) Attach or replace dust filter. 3) Collection tank full. 1) The dust filter is missing or damaged.
EXPLODED VIEW 13
PARTS LIST Key 1 Description VOD1PF.10.01.X1.09 2 Part Number Qty Included with Vac Handle Assembly 1 Power Head Assembly 1 3 TVQTZS.06.YZ.W2.00 Float 1 4 VI02SR.10.06 Filter Cage 1 5 TVQTXK.06.01.X2.01 Vacuum Port Assembly 1 Collection Tank 1 Latch Assembly 2 Base 1 6 7 VL01S0.20.02 8 9 VO40S0.21.00 Static Discharge Chain 1 10 TVQTJL.01.00 Caster 4 11 FV7902.01.01.