Use & Care Guide 18V 2-in-1 Cordless Swivel -Stick™ Vacuum MODEL NO.VSB1801NA Conforms to UL Standard UL1017 Certified to CSA STD C22.2 NO.243 www.vacmaster.com Cleva North America, Inc.
TABLE OF CONTENTS SECTION PAGE Important Safety Instructions...................................................................................................................3 Warranty...................................................................................................................................................7 Technical Specs………….........................................................................................................................7 Getting to Know Your Vacuum.......
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. WARNING - To reduce the risk of fire, electric shock, or injury: 1. Do not use outdoors or on wet surfaces. 2. Do not allow to be used as a toy.
14. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to hand vacuum, picking up or carrying the appliance. 15. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. 16. Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush affected area with water.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Product Disposal This product contains an internal Lithium-ion battery pack formulated from environmentally sensitive materials. This product must be disposed of properly with due care for the environment. Do not dispose of product with household garbage. Consult your local waste authority for information regarding available recycling or disposal options.
WARRANTY FOR ONE YEAR from the date of sale, this product is warranted against defects in material or workmanship when it is assembled, operated and maintained according to all supplied instructions. WITH PROOF OF SALE, a defective appliance will be replaced free of charge. For warranty coverage details to obtain free replacement, visit the web page: www.vacmaster.com or call (866) 384-8432.
GETTING TO KNOW YOUR VACUUM Handle Hand Vacuum On/Off Button Power Button Speed Shift Button Filter Foam Filter Basket Combo Accessory Tool Hand Vacuum Release Button Dust Cup Battery Charge Indicator Dust Cup Release Button On-Board Storage Clip Screw Main Body Hand Vacuum Charging Adapter Nozzle Release Button Motorized Brush Powerhead Charging Stand LED Headlights REPLACEMENT PARTS Item Filter Foam Charging Stand Combo Accessory Tool Charging Adapter On-Board Storage Clip Part No.
GENERAL ASSEMBLY INSTRUCTIONS Assembly Instructions: 1) Fit the end of the main body onto the neck of the motorized powerhead and click into place. 2) Insert the handle into the top of the main body and fix in position with the supplied locking screw. Note: Do not over-tighten. Use only hand tools and moderate torque. Click! 3) Insert the hand vacuum into the main body and click into place.
4) Insert vacuum support into charging base and lock into place. 5) Insert the charging adapter into the charging port on the side of charging base. 6) Plug the adapter into a wall outlet. Note: Use only the charger supplied with your cleaner to recharge. 7) Insert on-board storage clip onto handle and slide down lightly.
Charging Instructions: 1) Before charging, make sure unit is OFF. Insert the vacuum cleaner onto the charger as shown. Make sure the charging adapter is plugged into an outlet. 2) The battery indicator will show the progress of the charge. While the vacuum is being charged, the battery charge indicator will be flashing. Once fully charged, the indicator will light up continuously.
OPERATING INSTRUCTIONS Using Your Vacuum Cleaner: Once vacuum cleaner is charged, lift off the charging base. 1) To start the vacuum, push the Power button. The vacuum automatically starts in the HIGH speed position. 2) To switch the speed to LOW, push the speed shift button. Press this button again to switch back to HIGH speed. 3) To stop the vacuum, push the Power button. Using Your Hand Vacuum: 1) To remove the hand vacuum, press the release button and detach from the main body.
3) To clean difficult to reach areas, use the crevice tool or dusting brush by inserting the end of the tool into the hand vacuum. CAUTION Moving parts! To reduce the risk of personal injury, DO NOT touch the brush roll when vacuum is on. Contacting the brush roll while it is rotating can cut or cause other injuries. Always turn off before servicing. Use caution when operating near children.
MAINTAINING YOUR VACUUM CAUTION To reduce the risk of shock, remove vacuum cleaner from the charging base, and turn off before performing any service or maintenance. Emptying the Dust Container & Cleaning the Filter 1) Remove the hand vacuum from the main body by pressing the release button. 2) Hold the unit over a trash bin and use one hand to press the two dust cup release buttons to separate the dust cup from the hand vacuum body. 3) Remove the filter basket from the dust cup.
IMPORTANT: The filter, foam and basket must be completely dry before reuse. 6) Insert the clean and dry foam along with the filter into the basket. Fit the basket into the dust cup and reconnect the dust cup to the hand vacuum. 1 2 Note: Use warm water when cleaning the foam. WARNING Do not operate vacuum cleaner without filter installed. Cleaning the Motorized Powerhead & Blockages The brush roll may accumulate debris such as strings, hair and fibers.
Step 3 Step 4 5) Lock the brush in place by sliding the tab in the direction of the arrow. To Remove Powerhead Blockages: 1) To clean out the powerhead, press the nozzle release button and pull the powerhead away from the main vacuum body. Pins 2) Carefully remove any debris or blockage from the inside of the powerhead. 3) Reattach the powerhead onto the vacuum body.
TROUBLESHOOTING Should you have any problem(s) with your vacuum cleaner, review the table below for solutions to minor performance issues. WARNING Disconnect electrical supply before performing maintenance to the vacuum cleaner. Failure to do so could result in electrical shock or personal injury. PROBLEM POSSIBLE CAUSE Battery may be depleted. Charge the battery as instructed on page 11. Wrong charger being Be sure to use only the charger supplied with used. your product.
Brush roll is jammed. Motorized brush Brush roll needs to be not turning. reset. Remove obstruction. Follow instructions on page 15 and 16. Turn the unit off and remove the obstruction, then turn back on. Brush roll is not Remove brush roll and reinstall following installed well. instructions on page 15 and 16. Dust cup is full. Empty dust cup. Filter needs cleaning. Follow filter cleaning instructions on page 14. picking up or Filter needs to be To purchase online at www.vacmaster.