Instruction Manual

11
BLOWER OPERATION
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Make sure the collection tank is empty before using as a blower.
3. Remove the noise diffuser from the blower port. (g. 2)
4. Remove hose from the vacuum port and insert the locking end of the hose into the blower port
on the power head and lock into position. (g. 3)
5. Fit the desired extension wand and or nozzle to the free end of the vacuum hose. (g. 4)
6. Ensure the power switch is turned off and plug in the power supply. (g. 5)
7. Before turning ON the vac, rmly hold loose end of the hose. Turn the motor on by ipping
the switch to the ‘I’ ON position or use the vac with switch set to remote control setting and the
remote control. (g. 6)
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT
BE INHALED.
CAUTION:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.