Instruction Manual

12
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Disconnect the hose from the vacuum. (g. 2)
3. Remove the vacuum from the mounting rack.
4. Undo the latches and remove the power head from the collection tank. (g. 3)
5. Clear all dirt or debris from the collection tank and hose. (g. 4)
6. Clean the foam lter by washing it with water and mild soap. (g. 5)
7. Check the hose, attachments, and power cord to verify that they have not been damaged.
8. Place power head on collection tank and secure latches.
IMPORTANT!
Clean or change the lter regularly for best performance.
ALWAYS USE DUST
FILTER FOR DRY VACUUMING.
If the machine is used without the dust lter, the motor will burn
out and the warranty will be voided. Always keep spare dust lters on hand.
NOTICE!
The lters included are made of high quality materials designed to stop small dust
particles. The dust lter should be used for dry pick-up only. A dry dust lter is necessary to
pick up dust. If the dust lter is wet, it will clog quickly and be difcult to clean. Handle the lter
carefully when removing it for cleaning or replacing. Check the lters for tears or small holes. A
small hole can let dust pass through and out of the lter. Do not use a lter with holes or tears in
it; replace it immediately.
MAINTENANCE
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM COLLECTION TANK.