Instruction Manual

Table Of Contents

INSTALLING & CLEANING CARTRIDGE

FILTER

INSTALLING & CLEANING FOAM WET

FILTER

Installing Cartridge Filter

1. Verify that the power cord is disconnected from the outlet. (g. 1)

2. Remove power head and place in upside down position.

3. Install the cartridge lter over the lter cage with the at end of the lter towards the power head.

Carefully push lter in until it stops against the power head. (g. 2 & 3)

4. Place lter retainer on top of cartridge lter over the raised lip and tighten down by turning

retainer clockwise; do not over-tighten. (g. 4 & 5)

Removing and Cleaning Cartridge Filter

1. Unlock and remove the lter retainer by turning retainer handle counter clockwise.

2. Carefully hold and pull the cartridge lter up for removal. (g. 6)

3. Clean the cartridge lter by gently tapping or brushing dirt off. Cleaning should not be done

indoors in living areas. For optimal performance a new lter is recommended.

4. Install cleaned or new lter as instructed above in steps 2 and 3 of Installing Cartridge Filter.

5. Wet lters should be removed and allowed to air dry for 24 hours before installing onto the lter

cage.

Installing Foam Wet Filter

1. Verify that the power cord is disconnected from the outlet. (g. 1)

2. Remove power head and place in upside down position. Follow instructions to remove cartridge

lter.

3. Carefully slide foam wet lter down over the lter cage making sure the cage is completely

covered. (g. 2 & 3)

4. Place the power head onto the collection tank.

Cleaning Foam Wet Filter

1. With the removed power head in an upside down position, carefully remove foam wet lter. (g.

2. Use a mild soap and water solution to wash foam wet lter and rinse with clean water. (g. 5)

3. Allow lter to air dry before installing and using again.