Installation manual

Keypad Remote Control Options vacon  15
Email: [e-mail] • Fax [phone]
Step 11. Assembling the Remote Keypad Interface (XRKMK only)
1. Insert the connector stacker into the receptacle on the remote keypad assembly (removed in Step 9) as shown
in Figure 11 below.
2. Insert the keypad interface board onto the rear of the keypad assembly, being sure to engage the connector
stacker simultaneously.
3. Fasten the keypad interface assembly with five (5) M3.5 x 10 screws along with the loop clamp provided. Limit
installation torque to 12 in-lb. maximum.
Figure 11: Assembling the Remote Keypad Interface (XRKMK Option)