OWNERS MANUAL ® READ BEFORE OPERATING YOUR SYSTEM
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: * Read all instructions before using this appliance. WARNING: To reduce the risk of fire, electric shock or injury: * Always follow these safety instructions • Do not leave room when hose is plugged in to the inlet. Disconnect power before servicing. • Electric shock could occur if used on wet surfaces.
CAUTION: Do not use when rug (or floor) is wet. ATTENTION: Ne pas utiliser lorsque le tapis (ou le plancher) est moduille. SAVE THESE INSTRUCTIONS * THIS IS NOT A WET VAC * -WARNING- ELECTRIC SHOCK COULD OCCUR IF USED ON WET SURFACES GROUNDING INSTRUCTIONS FOR CORD CONNECTED APPLIANCE This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock.
Parts Cannot be plumbed for use as a central vac. DO NOT USE AS A WET VAC Additional tools needed for installation: • Level • Rubber Mallet • Electric Drill • 1/8” drill bit (If mounting on block or concrete wall, you will need masonry bit & plastic or lead anchors - not provided) Other items included with this system... Tool kit for standard Garage Vac 8 1 4 5 3 2 6 7 1. Hose 2. Hose Hanger 3. Dusting Brush 4. Upholstery Tool 5. Crevice Tool 6. Telescopic Wand 7. Floor Brush 8.
Installation & Mounting CHOOSE THE MOUNTING LOCATION • The unit must be mounted within 5 feet of an electrical outlet. Do not use an extension cord. • • • The unit should be mounted so that it is in a dry location and out of the way, but still accessible for emptying and accessing the utility valves. Suggested mounting: Minimum of 12 inches between unit lid and ceiling or shelving. Do not install this unit where ambient temperature regularly exceeds 120 degrees F. Vacuums must breathe...do not enclose.
FIRST TIME USE Before using your system for the first time, follow these 3 steps. Protector plate must be installed properly for the vacuum to work 1 Make sure the PP101 Protector Plate is in place. This is necessary for proper suction. Upon receiving your vacuum system, lift off the lid. The protector plate should be located inside the can just below the HEPA bag. PP101 Protector Plate The protector plate is installed correctly when it lays flat, prong side down, directly under the HEPA bag.
USING YOUR SYSTEM Vacuuming Inserting the hose The hose connects to the system through the utility valve inlet on the front of the unit by lifting the round door open and inserting the hose. (Fig. 1) 1 See below for using your attachments & cleaning tools. On/Off Switch Insert the hose before turning the unit on. The system is turned on and off by flipping the switch on the side of the unit.
MAINTENANCE This system uses a sealed HEPA type bag. The mass of dirt and debris is picked up by your vacuum and deposited into the bag inside your dirt canister. Emptying your Dirt Can To remove accumulation, follow these steps: 1 Remove the lid by unhooking the clamps & releasing the latches on the top of the canister. (Fig. 1) Lift lid straight up. (Fig.
WARRANTY 5 YEAR LIMITED* WARRANTY Domestic Residential Use only This Warranty gives you specific legal rights, you may also have other rights which vary from State to State (or Province). ITEMS COVERED * The VacuMaid® GARAGE VAC system is warranted for a period of 5 years. Hoses, floor brushes, and cleaning tools are warranted for a period of 2 years. All warranties commence from the original date of purchase.
TROUBLESHOOTING Most problems that develop can be fixed easily by following the below suggested solutions: Vacuum cleaner won’t run • • • Be sure the unit is plugged in. Be sure you turned the system on. Check your circuit breaker panel. Make sure there is not too much on that circuit causing it to trip. Low suction or no suction • • First, see above.
BAG REPLACEMENTS HPB2HPK 3 pack of HEPA filtered bags Available on AMAZON or at www.vacumaid.
For replacement bags or to order additional tools or accessories, visit us at www.vacumaid.com or give us a call at 1-800-221-1862 To register your product online, go to www.vacumaid.