emission condenser Peltronic Manual
Table Of Contents
- Part I
- Reset / Language selection
- Safety information!
- Technical data
- Use and operation
- Installing a pump in a vacuum system
- Notes regarding the (dry) ice condenser
- Notes concerning the operation of the inlet condenser IK
- Notes concerning the operation of the Peltronic emission condenser
- Notes concerning the operation of pumping units with silencer
- During operation
- Important notes regarding the use of gas ballast
- Important notes concerning the operation of the exhaust waste vapor condenser
- Shutdown & storage
- CVC 3000 Vacuum controller
- Menu guide
- Pump down function
- Vac Control function
- Auto mode
- Program function
- VACUULAN function
- Application examples
- Configuration
- Part II
- Readjustment of CVC 3000
- Calibration in the factory
- Cleaning the pressure transducer
- Interface parameters
- Accessories
- Troubleshooting
- Replacing diaphragms and valves
- Cleaning and inspecting the pump heads
- Disassembling the housing cover at the side of the emission condenser
- Replacing the diaphragm
- Assembling the housing cover at the side of the emission condenser
- Disassembling the housing cover at the side of the ON/OFF switch
- Assembling the housing cover at the side of the ON/OFF switch
- Assembling the fittings
- Cleaning and replacing components
- Notes on return to the factory
- Warranty
- Health and safety clearance form
- EC Declaration of Conformity of the Machinery
page 102 of 120
+ Service only one side of the pump at a time to avoid the mixing of
parts.
PC 3001 VARIO
pro
IK
Disassemble the inlet condenser.
➨ Loosen the union nut at the inlet of the
pump.
➨ Remove the 4 screws afxing the counter
holder of the exhaust vapor condenser with
a Torx driver T10.
➨ Remove the inlet condenser. In doing so
pull the PTFE hose out of the inlet of the
inlet condenser.
PC 3001 VARIO
pro
TE
Disassemble the emission condenser TE.
➨ Loosen the union nut at the inlet of the emis-
sion condenser TE.
➨ Remove the 2 screws afxing the mounting
plate of the emission condenser TE with a
Phillips screw driver size 2.
➨ Remove the emission condenser TE. In do-
ing so pull the PTFE hose out of the inlet of
the emission condenser TE.
PC 3001 VARIO
pro
EK Peltronic
Disassemble the Peltronic emission condens-
er. Detach the coupling of the hose connection
at the Peltronic emission condenser.
➨ Open the hose clip with a slotted screw-
driver.
➨ Pull the tubing off the hose connector.
➨ Remove the 2 screws afxing the mounting
plate of the Peltronic emission condenser
with a Phillips screw driver size 2.
➨ Remove the Peltronic emission condenser.
In doing so pull the PTFE hose out of the
inlet of the Peltronic emission condenser.
O