emission condenser Peltronic Manual
Table Of Contents
- Part I
- Reset / Language selection
- Safety information!
- Technical data
- Use and operation
- Installing a pump in a vacuum system
- Notes regarding the (dry) ice condenser
- Notes concerning the operation of the inlet condenser IK
- Notes concerning the operation of the Peltronic emission condenser
- Notes concerning the operation of pumping units with silencer
- During operation
- Important notes regarding the use of gas ballast
- Important notes concerning the operation of the exhaust waste vapor condenser
- Shutdown & storage
- CVC 3000 Vacuum controller
- Menu guide
- Pump down function
- Vac Control function
- Auto mode
- Program function
- VACUULAN function
- Application examples
- Configuration
- Part II
- Readjustment of CVC 3000
- Calibration in the factory
- Cleaning the pressure transducer
- Interface parameters
- Accessories
- Troubleshooting
- Replacing diaphragms and valves
- Cleaning and inspecting the pump heads
- Disassembling the housing cover at the side of the emission condenser
- Replacing the diaphragm
- Assembling the housing cover at the side of the emission condenser
- Disassembling the housing cover at the side of the ON/OFF switch
- Assembling the housing cover at the side of the ON/OFF switch
- Assembling the fittings
- Cleaning and replacing components
- Notes on return to the factory
- Warranty
- Health and safety clearance form
- EC Declaration of Conformity of the Machinery
page 107 of 120
➨ Put on head covers (C).
+ Pay attention to the correct orientation of
the head covers (see gure below).
+ Make sure that the diaphragms stay cen-
tered with respect to the bores so that they
will become clamped uniformly between
housing (I) and head covers (C).
➨ Put the valves (B) in place. See gure below for the correct position of
the valves:
Inlet side of pump head: The valve tongue points at the kidney-shaped
orice in the valve seat (1).
Outlet side of pump head: The valve is oriented the opposite direction
as the valve at the inlet side. Round orice under the valve tongue (2).
outlet
side (2)
inlet
side (1)
Scheme of pump heads with head covers and valves