emission condenser Peltronic Manual
Table Of Contents
- Part I
- Reset / Language selection
- Safety information!
- Technical data
- Use and operation
- Installing a pump in a vacuum system
- Notes regarding the (dry) ice condenser
- Notes concerning the operation of the inlet condenser IK
- Notes concerning the operation of the Peltronic emission condenser
- Notes concerning the operation of pumping units with silencer
- During operation
- Important notes regarding the use of gas ballast
- Important notes concerning the operation of the exhaust waste vapor condenser
- Shutdown & storage
- CVC 3000 Vacuum controller
- Menu guide
- Pump down function
- Vac Control function
- Auto mode
- Program function
- VACUULAN function
- Application examples
- Configuration
- Part II
- Readjustment of CVC 3000
- Calibration in the factory
- Cleaning the pressure transducer
- Interface parameters
- Accessories
- Troubleshooting
- Replacing diaphragms and valves
- Cleaning and inspecting the pump heads
- Disassembling the housing cover at the side of the emission condenser
- Replacing the diaphragm
- Assembling the housing cover at the side of the emission condenser
- Disassembling the housing cover at the side of the ON/OFF switch
- Assembling the housing cover at the side of the ON/OFF switch
- Assembling the fittings
- Cleaning and replacing components
- Notes on return to the factory
- Warranty
- Health and safety clearance form
- EC Declaration of Conformity of the Machinery
page 110 of 120
➨ Tighten the union nut (K) of the hose con-
nection with an open-ended wrench w/f 17.
+ Tighten the union nut rst by hand and then
tighten one full turn using the open ended
wrench.
PC 3001 VARIO
pro
/ PC 3001 VARIO
pro
IK
Assemble the exhaust vapor condenser.
➨ Feed the PTFE hose from the pump outlet
into the inlet of the exhaust vapor condens-
er.
➨ Mount the condenser with the counter hold-
er (Torx screws T10) to the pump.
➨ Fasten union nut.
PC 3001 VARIO
pro
IK
Assemble the inlet condenser.
➨ Slip the hose from the inlet of the pump onto
the hose connector of the inlet condenser.
➨ Mount the condenser with the counter hold-
er (Torx screws T10) to the pump.
➨ Tighten the union nut rst by hand and then
tighten one full turn using the open ended
wrench.
PC 3001 VARIO
pro
TE
Assemble the emission condenser TE.
➨ Feed the PTFE hose from the pump outlet
into the inlet of the emission condenser TE.
➨ Attach the mounting plate of the emission
condenser TE with 2 screws at the hous-
ing cover of the pumping unit; use a Phil-
lips screw driver size 2. Pay attention to the
cage nuts in the groove of the housing cov-
er.
➨ Fasten union nut.