emission condenser Peltronic Manual
Table Of Contents
- Part I
- Reset / Language selection
- Safety information!
- Technical data
- Use and operation
- Installing a pump in a vacuum system
- Notes regarding the (dry) ice condenser
- Notes concerning the operation of the inlet condenser IK
- Notes concerning the operation of the Peltronic emission condenser
- Notes concerning the operation of pumping units with silencer
- During operation
- Important notes regarding the use of gas ballast
- Important notes concerning the operation of the exhaust waste vapor condenser
- Shutdown & storage
- CVC 3000 Vacuum controller
- Menu guide
- Pump down function
- Vac Control function
- Auto mode
- Program function
- VACUULAN function
- Application examples
- Configuration
- Part II
- Readjustment of CVC 3000
- Calibration in the factory
- Cleaning the pressure transducer
- Interface parameters
- Accessories
- Troubleshooting
- Replacing diaphragms and valves
- Cleaning and inspecting the pump heads
- Disassembling the housing cover at the side of the emission condenser
- Replacing the diaphragm
- Assembling the housing cover at the side of the emission condenser
- Disassembling the housing cover at the side of the ON/OFF switch
- Assembling the housing cover at the side of the ON/OFF switch
- Assembling the fittings
- Cleaning and replacing components
- Notes on return to the factory
- Warranty
- Health and safety clearance form
- EC Declaration of Conformity of the Machinery
page 27 of 120
Technical data
General technical data valid for all pumping units
Maximum pumping speed
(ISO 21360)
cfm
(m
3
/h)
1.2
(2.0)
Ultimate vacuum (absolute)
without gas ballast*
Torr
(mbar)
1.5
(2)
Ultimate vacuum (absolute)
with gas ballast*
Torr
(mbar)
3
(4)
Maximum permissible inlet and outlet
pressure (absolute)
psi
(bar)
16
(1.1)
Maximum permissible pressure difference
between inlet and outlet
psi
(bar)
16
(1.1)
Maximum permissible pressure (abso-
lute) at gas ballast valve
psi
(bar)
17.5
(1.2)
Permissible ambient temperature
storage / operation
°F
(°C)
14 to 140 / 50 to 104
(-10 to +60 / +10 to +40)
Permissible relative atmospheric mois-
ture during operation (no condensation)
% 30 to 85
Maximum permissible installation altitude
above mean sea level
ft
(m)
6500
(2000)
Rated motor power
hp
(kW)
0.21
(0.16)
No-load speed** rpm 0 - 3000
Maximum permissible range of supply
voltage ( ±10% )
Attention: Observe specications of
rating plate!
100-120 V~ 50-60 Hz
200-230 V~ 50-60 Hz
Maximum rated current at:
100-120 V~ 50-60 Hz
200-230 V~ 50-60 Hz
A
A
1.6
0.7
Device fuse
Fuse of VACUU•BUS 24V DC supply
F7A fuse on the circuit board
T0.5A slow blow fuse (with
automatic reset) on the circuit
board
Motor protection
current limitation
(temperature sensor on the
circuit board)
Degree of protection IEC 529 IP 20
Volume of catchpot
quarts
(ml)
0.52
(500)
A-weighted emission sound pressure
level*** (uncertainty K
pA
: 3 dB(A))
dB(A) 42