emission condenser Peltronic Manual
Table Of Contents
- Part I
- Reset / Language selection
- Safety information!
- Technical data
- Use and operation
- Installing a pump in a vacuum system
- Notes regarding the (dry) ice condenser
- Notes concerning the operation of the inlet condenser IK
- Notes concerning the operation of the Peltronic emission condenser
- Notes concerning the operation of pumping units with silencer
- During operation
- Important notes regarding the use of gas ballast
- Important notes concerning the operation of the exhaust waste vapor condenser
- Shutdown & storage
- CVC 3000 Vacuum controller
- Menu guide
- Pump down function
- Vac Control function
- Auto mode
- Program function
- VACUULAN function
- Application examples
- Configuration
- Part II
- Readjustment of CVC 3000
- Calibration in the factory
- Cleaning the pressure transducer
- Interface parameters
- Accessories
- Troubleshooting
- Replacing diaphragms and valves
- Cleaning and inspecting the pump heads
- Disassembling the housing cover at the side of the emission condenser
- Replacing the diaphragm
- Assembling the housing cover at the side of the emission condenser
- Disassembling the housing cover at the side of the ON/OFF switch
- Assembling the housing cover at the side of the ON/OFF switch
- Assembling the fittings
- Cleaning and replacing components
- Notes on return to the factory
- Warranty
- Health and safety clearance form
- EC Declaration of Conformity of the Machinery
page 53 of 120
Selection knob
• Press to reach the set-up menu of the function
• Turn to choose the parameter you want to modify
• Press to select the parameter you want to modify
• Turn to change the set value of the parameter
• Press to conrm change of value and to reach further
parameters, or to leave the set-up menu
Pump down / Vac control / Auto mode (only with VACUU•BUS-
compatible VARIO pump) / Program / VACUULAN / Conguration
Selected function (displayed in the upper left corner):
A ”function” is one of the following operation modes of the CVC 3000
controller:
1013 . 2
mbar
Vac control
100
Display and symbols
mbar / Torr / hPa Preselected pressure unit
1013.2 Actual absolute pressure at the pressure transducer
Other display symbols: