Instruction Manual

Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. Manual-no.: 999084 / 05/10/2009
page 19 of 46
General view of factory-set modes
VNC 1
press key during switching on
* only with speed controlled VACUUBRAND VARIO pumps
** designated for VACUUBRAND diaphragm pumps type ME 16(C), MD 8(C),
MD 12(C) und MV 10(C)
Esc
VACUULAN
V. 2.00
Attention: When connecting pumps pay attention to the breaking capacity of the
IEC socket (see ”Technical Data”)!
Factory-set mode ”Vacuum control” (pControl)
Controller controls
- pump and / or isolation valve according to preset pressure in two-
point controller continuous pumping
- VARIO pump exactly according to preset pressure*
- coolant valve
Factory-set mode ”VACUU•LAN” (VACUULAN)
Controller controls
- pump according to preset pressure and time
- VARIO pumps according to preset pressure and time*
- coolant valve
Factory-set mode ”VACUU•LAN” for pumps with 8 cylinders** (VCL
8cyl)
Controller controls
- pump according to preset pressure and time
- coolant valve
Factory-set mode ”RC 5/RC 6 management” (RC 5/RC 6)
1)
Controller controls
- chemistry-HYBRID-pump (pressure check)
- isolation valve
- bypass valve
- coolant valve
1)
Attention: For factory-set mode ”RC 5/RC 6 management” please order sepa-
rate instructions for use!
factory-set mode