Specifications
AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. B Page 18 of 52
Note: If AutoTrak 2.0 CPU green light is blinking (which indicates standby mode), restart system by:
Turn the rear mounted Power Switch OFF for a few seconds and then back ON - or - remove
CPU power and then restore it - or - push the recessed Restart Button for a few seconds and
then release it.
3) Plug the IR Reference Camera into a monitor for set-up purposes. With the IR Reference plugged
into a monitor, the IR LEDs should be visible as white dots on a black background. These LEDs will
be tracked as the presenter moves around the room. To aid in set-up, a temporary RCA Y-cable may
be used to split the signal between the monitor and CPU.
4) Select the Presets Tab①, then the Reference Camera Tab②. Use the Position③ buttons to Center
the IR lanyard in the monitor display horizontally and vertically.
5) Use the Zoom④ buttons (tele & wide) to increase the size of the lanyard in the display until it is
approximately 1/3 the size of the video image on the monitor. Use the Position③ up/down buttons to
locate the lanyard in the center of the screen so the presenter’s head is in the top ½ of the screen.
6) Click the Save⑤ button to save this default zoom and tilt position for the IR Reference Camera. The
Load⑥ button is for recalling a previously saved preset.
7) Plug the composite video from the IR Reference Camera back into the middle yellow RCA-F jack on
the back of the AutoTrak 2.0 CPU.
①
②
③
⑤
⑥
④