Specifications

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. B Page 34 of 52
Setup Pan
Speed
This value, degrees’ is used in the ‘User Interface’ to set camera presets.
Setup Tilt
Speed
This value, degrees’ is used in the ‘User Interface’ to set camera presets.
AutoPresenter
Port
This string represents the Device name of the serial port used to communicate with
an AutoPresenter.
Reference
Camera Port
This string represents the Device name of the serial port used to communicate with
the IR Reference Camera.
Tracking
Camera Port
This string represents the Device name of the serial port used to communicate with
the Tracking Camera.
Iris Control
Ref. Camera
This parameter is used to reduce the light and increase the contrast of the lanyard IR
emitters. Default value is in parenthesis.
Iris Control
Tracking
Camera
This parameter is used to adjust the iris (f-stop) to prevent blooming between light
and dark areas in auto iris mode. The Default value is Auto mode, but if blooming
within the presenter area is a problem, switch to manual mode.
Camera Select
This parameter is used select either the AutoTrak 2.0 HD-18 or AutoTrak 2.0 HD-20
as the Tracking Camera (Iris values are different between cameras). Note: The HD-
18 is always the reference camera.
Auto Focus
Type
This parameter allows the user to select the Auto Focus method. The two (2)
options are; Low Light – works in average and even light conditions, Low and Bright
Light – works better in rooms with bright spots and reflections. Bright light containing
IR will hinder AutoTrak 2.0 operation.
Details on the Vaddio AutoTrak 2.0 HD-18 Pan/Tilt/Zoom Cameras used in the
AutoTrak 2.0 Systems:
④
①
②
③
Camera Features:
1) Camera/Sensor/Optics:
1/3-Type, Megapixel HD CCD image sensor is
combined with an 18x optical zoom lens, for
capturing high-quality HD video.
2) Tally Light:
For the Tracking, the tally light is not used. For
the IR Reference camera, the tally light will blink
when it is acquiring the subject wearing the IR
Lanyard and when it locks on the IR Lanyard the
tally light will remain on.
3) IR Sensors:
IR sensors are built into the front of the
WallVIEW HD-18 to receive IR signals from the
IR remote control supplied with the camera.
4) Power Light:
A blue power light is illuminated when the
camera is turned on.
Front View of Vaddio HD-18
HD PTZ Camera