Specifications

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. B Page 6 of 52
AutoTrak 2.0 Components:
AutoTrak 2.0 CPU
Note: The AutoTrak 2.0 CPU may be subject to change in cosmetics due to the extraordinarily turbulent
nature of the PC industry, parts availability and model year upgrades. If changes are made, Vaddio will
be certain to make changes in the documentation accordingly. The AutoTrak 2.0 CPU is a 1-RU rack
mount computer that will come preloaded with the AutoTrak 2.0 software. The exact specifications are
subject to change and any changes that will be made will be in the spirit of product improvement only.
The AutoTrak 2.0 CPU uses an Intel® Atom™ Dual Core Processor, Intel Graphics Media Accelerator,
1GB DDR2 Memory, four (4) RS-232 Ports, six (6) USB 2.0 ports, two (2) PS/2 interfaces for
keyboard/mouse, 16GB Compact Flash and Video capture card.
An important feature: After the AutoTrak 2.0 CPU and software is configured using the mouse, keyboard
and monitor, these I/O devices can be removed to prevent any unauthorized access to the system. To
reattach the mouse and keyboard, the system will need to be rebooted to recognize these devices.
 Front Panel Controls of AutoTrak 2.0 Worldwide CPU:
1) Power Indicator: Illuminates when power in on
2) Hard Drive Activity Indicator: Indicates when solid state drive is active
3) Recessed Reset Switch: A Momentary press of this switch resets the system and prepares the
CPU for an orderly shut-down. When the green light blinks, it is ready to be turned off or it is safe
to restart (power cycle).
4) USB Ports: Two (2) Front Panel USB Ports
 Rear Panel of AutoTrak 2.0 Worldwide CPU:
1) Power Receptacle: IEC60320 C14 for power cable
2) Power Switch: Turns ON/OFF AutoTrak 2.0 CPU
NOTE: Do not turn the power off with the power switch on the rear panel or rack
power switch unless the computer has been shut down first. Repeated power
cycling without shutting down the computer first will cause harm to the system
(like all other business computers) and any warranties will be voided.
3) COM PORT 1: RS-232 Port for HD-18 IR Reference Camera
4) COM PORT 2: RS-232 Port for HD-18 Tracking Camera
5) COM PORT 3: Use RS-232 Port 3 when AutoTrak 2.0 is used with the AutoTrak POD or the
AutoPresenter 6x1 HD Switcher
6) RGBHV (on DE-15) Output: To setup and view software menus (800 x 600 @ 60Hz)
7) Ethernet Ports: Not used with AutoTrak 2.0 Application
8) USB Ports: Four USB Ports on the back panel for use with Keyboard, Mouse and USB Flash
Drive
9) Audio I/O: Not used with AutoTrak 2.0 Application
10) Video Input Port: Plug the HD-18 IR Reference Camera into the center yellow composite video
connector
①②
③
④
①
②
③
④ ⑤
⑥
⑦
⑧
⑨
⑩
Shut Down
CPU First