User guide

AutoTrak 2.0 Camera Tracking System
AutoTrak 2.0 Camera Tracking System - Document Number 342-0382 Rev. E Page 20 of 52
1) On the Tuning① / Tracking② Camera page, Camera Select③ automatically detects the camera
being used as the Tracking Camera. The auto-detect choices are between the HD-18 and HD-20.
2) The Iris④ control allows the user to set the specific f-stop (iris value) of the camera for challenging
lighting environments or use the system in Automatic mode. The system will auto set this value.
3) The Auto Focus Type⑤ allows the user to select the type of auto focus that is preferred. The Low and
Bright Light setting is effective for bright to low light conditions. The Low Light setting allows for faster
focusing in low light conditions. The system will auto set this value.
4) The Tilt Correction⑥ angle is to compensate for the different heights of the camera lens when the
HD-18 cameras are mounted in a co-linear stacked array which is a highly preferred and
recommended configuration. This correction angle is automatically figured by the system when the
Tracking Camera Preset or the Reference Camera Preset is saved assuring that both cameras are
pointing at the same target.
5) The Zoom Position⑦ is a reference position stored as part of the system Tracking Camera Preset.
6) The Pan Correction parameter should only be used: if there is absolutely no way that the
cameras can be stacked in a co-linear array and have to be used side by side. The side by side
configuration is not recommended. The stacked configuration is highly preferred.
7) Auto or Manual White Balance. In Manual mode, access to the Red and Blue levels is allowed to
manually adjust the camera’s color/white balance.
8) To start AutoTrak 2.0 click the Resume button.
①
②
③
④
⑤
⑥
⑦
⑨
⑨
⑩
⑩
⑧
⑧
⑨